Improving the accuracy of stereolithography 3D printed Al 2 O 3 microcomponents by adding photoabsorber: Fundamentals and experiments
Jingyi Chen,Ruyue Su,Xiaofei Zhai,Yaru Wang,Xiong Gao,Xueqin Zhang,Yanpeng Zhang,Yan Zhang,Sheng Liu,Rujie He
DOI: https://doi.org/10.1016/j.jmrt.2023.09.309
IF: 6.267
2023-10-12
Journal of Materials Research and Technology
Abstract:Ceramic microcomponents have a wide range of applications in microfluidic, sensors, etc. Stereolithography 3D printing technology provided a shortcut for the preparation of this small-size and complex component. With the development of device miniaturization, the existing stereolithography forms cannot meet the demand. To prepare smaller components, it is necessary to decrease the slice thickness ( Cs ). But during the stereolithography 3D printing, ceramic is usually easy to over-cure, leading to the key issue in the stereolithography of ceramic microcomponents: the mismatching between the curing thickness ( Cp ) and the slice thickness ( Cs ). To solve the problem above, this paper started from the stereolithography mechanism of the ceramic/resin slurry and adjusted the matching relationship between Cp and Cs theoretically by adding a photoabsorber. Then, from the experiments, the influence of different content of photoabsorber (carbon black) on curing thickness, printing accuracy, and sintering accuracy, were studied. Al 2 O 3 ceramic microcomponents that met the design requirements were thus prepared. These results would help in the development of stereolithography 3D printing of ceramic microcomponents.
materials science, multidisciplinary,metallurgy & metallurgical engineering