Experimental investigation of the effect of LiBr on the high-pressure part of a ternary working fluid ammonia absorption refrigeration system

Mengkai Xu,Shuhong Li,Zhenghao Jin,Weixue Jiang,Kai Du
DOI: https://doi.org/10.1016/j.applthermaleng.2020.116521
IF: 6.4
2021-01-01
Applied Thermal Engineering
Abstract:This paper experimentally studies the influence of lithium bromide concentration on the coefficient of performance (COP) and other operating parameters in the high-pressure part of a ternary working fluid ammonia-water absorption refrigeration system. The lithium bromide concentrations in the ternary working fluid were 5%, 10%, 15%, and 20%. The lithium bromide concentration is the ratio of the mass of lithium bromide and the sum mass of lithium bromide and water. The generation temperature ranged from 100 degrees C to 130 degrees C, evaporation temperature was 10 degrees C, and the cooling water temperature was 28 degrees C. The experiment results show that 15% is the optimum lithium bromide concentration, and the highest COP is 0.408 when the generation temperature was 130 degrees C, which is 7.2% higher than AARS with binary working fluid. The COP improved because of the reduction of rectification cooling load, heat recovery, and operating pressure. The cooling water mass flows in the reflux condenser were reduced when applying lithium bromide in the working fluid, and the rectification cooling load decreases as low as 16% of the heating load in the generator. The heat recovery in the solution heat exchanger is too large after using ternary working fluid because the heat transfer coefficient of the ternary solution rises. Moreover, the generation pressure is related to the condensing temperature rather than lithium bromide concentration. Generally, AARS operates more efficiently, and the main components can be miniaturized with the application of ammonia-water-lithium bromide ternary working fluid.
What problem does this paper attempt to address?