Abstract:A new lower tungsten divertor has been developed and installed in the EAST superconducting tokamak to replace the previous graphite divertor with power handling capability increasing from <2 MW m−2 to ∼10 MW m−2, aiming at achieving long-pulse H-mode operations in a full metal wall environment with the steady-state divertor heat flux of ∼10 MW m−2. A new divertor concept, ‘corner slot’ (CS) divertor, has been employed. By using the ‘corner effect’, a strongly dissipative divertor with the local buildup of high neutral pressure near the corner can be achieved, so that stable detachment can be maintained across the entire outer target plate with a relatively lower impurity seeding rate, at a separatrix density compatible with advanced steady-state core scenarios. These are essential for achieving efficient current drive with low-hybrid waves, a low core impurity concentration and thus a low loop voltage for fully non-inductive long-pulse operations. Compared with the highly closed small-angle-slot divertor in DIII-D, the new divertor in EAST exhibits the following merits: (1) a much simpler geometry with integral cassette body structure, combining vertical and horizontal target plates, which are more suitable for actively water-cooled W/Cu plasma facing components, facilitating installation precision control for minimizing surface misalignment, achieving high engineering reliability and lowering the capital cost as well; (2) it has much greater flexibility in magnetic configurations, allowing for the position of the outer strike point on either vertical or horizontal target plates to accommodate a relatively wide triangularity range, δ l = 0.4–0.6, thus enabling to explore various advanced scenarios. A water-cooled copper in-vessel coil has been installed under the dome. Five supersonic molecular beam injection systems have been mounted in the divertor to achieve faster and more precise feedback control of the gas injection rate. Furthermore, this new divertor allows for double null divertor operation and slowly sweeping the outer strike point across the horizontal and vertical target plates to spread the heat flux for long-pulse operations. Preliminary experimental results demonstrate the ‘corner effect’ and are in good agreement with simulations using SOLPS-ITER code including drifts. The EAST new divertor provides a test-bed for the closed divertor concept to achieve steady-state detachment operation at high power. Next step, a more closed divertor, ‘sharp-cornered slot’ divertor, building upon the current CS divertor concept, has been proposed as a candidate for the EAST upper divertor upgrade.

Sustained radiative divertor in high-performance grassy-ELM regime with metal wall towards long-pulse operation in EAST

Divertor Power Deposition Control and ELM Mitigation with Supersonic Molecular Beam Injection in the EAST Tokamak

Divertor Impurity Seeding with a New Feedback Control Scheme for Maintaining Good Core Confinement in Grassy-Elm H-mode Regime with Tungsten Monoblock Divertor in EAST

Physics Design of New Lower Tungsten Divertor for Long-Pulse High-Power Operations in EAST

Divertor Detachment with Neon Seeding in Grassy-Elm H-mode in EAST

Long-pulse H-mode operation with stored-energy monitoring for detachment feedback control with a new lower tungsten divertor in EAST

Power Balance Investigation in Long-Pulse High-Performance Discharges with ITER-like Tungsten Divertor on EAST

A Long-Pulse Small Edge-Localized-mode High-Confinement Plasma with Detachment Feedback Control by Floating Potential in an Experimental Advanced Superconducting Tokamak in a Metal Wall Environment

A promising grassy elm regime for high-performance steady- state operations with metal wall in east and cfetr

Compatibility of Large ELM Control and Stable Partial Detachment with Neon/argon Seeding in EAST

Advances in the Long-Pulse Steady-State High Beta H-mode Scenario with Active Controls of Divertor Heat and Particle Fluxes in EAST

Impact of machine parameters on divertor detachment with ITER-like tungsten divertor in EAST

Achievement of Radiative Feedback Control for Long-Pulse Operation on EAST

Active Control of Divertor Heat and Particle Fluxes in EAST Towards Advanced Steady State Operations

Progress of Divertor Heat and Particle Flux Control in EAST for Advanced Steady-State Operation in the Last 10 Years

Study on Pedestal Fluctuations in H-modes Without Large ELMs During the Transition to a Detached Tungsten Divertor in EAST

Achievements of Actively Controlled Divertor Detachment Compatible with Sustained High Confinement Core in DIII-D and EAST

Advances In Plasma-Wall Interaction Control For H-Mode Operation Over 100 S With Iter-Like Tungsten Divertor On East

Approaches Towards Long-Pulse Divertor Operations on EAST by Active Control of Plasma–wall Interactions

Integrated Operation of Steady-State Long-Pulse H-mode in Experimental Advanced Superconducting Tokamak

Progress of Physics Understanding for Long Pulse High-Performance Plasmas on EAST Towards the Steady-State Operation of ITER and CFETR