Abstract:A new lower tungsten divertor has been developed and installed in the EAST superconducting tokamak to replace the previous graphite divertor with power handling capability increasing from <2 MW m−2 to ∼10 MW m−2, aiming at achieving long-pulse H-mode operations in a full metal wall environment with the steady-state divertor heat flux of ∼10 MW m−2. A new divertor concept, ‘corner slot’ (CS) divertor, has been employed. By using the ‘corner effect’, a strongly dissipative divertor with the local buildup of high neutral pressure near the corner can be achieved, so that stable detachment can be maintained across the entire outer target plate with a relatively lower impurity seeding rate, at a separatrix density compatible with advanced steady-state core scenarios. These are essential for achieving efficient current drive with low-hybrid waves, a low core impurity concentration and thus a low loop voltage for fully non-inductive long-pulse operations. Compared with the highly closed small-angle-slot divertor in DIII-D, the new divertor in EAST exhibits the following merits: (1) a much simpler geometry with integral cassette body structure, combining vertical and horizontal target plates, which are more suitable for actively water-cooled W/Cu plasma facing components, facilitating installation precision control for minimizing surface misalignment, achieving high engineering reliability and lowering the capital cost as well; (2) it has much greater flexibility in magnetic configurations, allowing for the position of the outer strike point on either vertical or horizontal target plates to accommodate a relatively wide triangularity range, δ l = 0.4–0.6, thus enabling to explore various advanced scenarios. A water-cooled copper in-vessel coil has been installed under the dome. Five supersonic molecular beam injection systems have been mounted in the divertor to achieve faster and more precise feedback control of the gas injection rate. Furthermore, this new divertor allows for double null divertor operation and slowly sweeping the outer strike point across the horizontal and vertical target plates to spread the heat flux for long-pulse operations. Preliminary experimental results demonstrate the ‘corner effect’ and are in good agreement with simulations using SOLPS-ITER code including drifts. The EAST new divertor provides a test-bed for the closed divertor concept to achieve steady-state detachment operation at high power. Next step, a more closed divertor, ‘sharp-cornered slot’ divertor, building upon the current CS divertor concept, has been proposed as a candidate for the EAST upper divertor upgrade.

Approaches Towards Long-Pulse Divertor Operations on EAST by Active Control of Plasma–wall Interactions

Divertor Power Deposition Control and ELM Mitigation with Supersonic Molecular Beam Injection in the EAST Tokamak

Physics Design of New Lower Tungsten Divertor for Long-Pulse High-Power Operations in EAST

Power Balance Investigation in Long-Pulse High-Performance Discharges with ITER-like Tungsten Divertor on EAST

Active Control of Divertor Heat and Particle Fluxes in EAST Towards Advanced Steady State Operations

Advances In Plasma-Wall Interaction Control For H-Mode Operation Over 100 S With Iter-Like Tungsten Divertor On East

1 EXD / P 3-14 Recent Advances in Long Pulse Divertor Operations on EAST

Particle and Power Deposition on Divertor Targets in EAST H-mode Plasmas

Recent Advances in Long-Pulse High-Confinement Plasma Operations in Experimental Advanced Superconducting Tokamak

Advances in the Long-Pulse Steady-State High Beta H-mode Scenario with Active Controls of Divertor Heat and Particle Fluxes in EAST

Progress of Divertor Heat and Particle Flux Control in EAST for Advanced Steady-State Operation in the Last 10 Years

Advances in H-mode Physics for Long-Pulse Operation on EAST

Advances in plasma-wall interaction control for h-mode operation over 100s with iter-like w divertor on east

Divertor Impurity Seeding with a New Feedback Control Scheme for Maintaining Good Core Confinement in Grassy-Elm H-mode Regime with Tungsten Monoblock Divertor in EAST

Integrated Operation of Steady-State Long-Pulse H-mode in Experimental Advanced Superconducting Tokamak

Sustained radiative divertor in high-performance grassy-ELM regime with metal wall towards long-pulse operation in EAST

Progress on In-Vessel Poloidal Field Coils Optimization Design for Alternative Divertor Configuration Studies on the EAST Tokamak

Development of High Poloidal Beta, Steady-State Scenario with ITER-like Tungsten Divertor on EAST

Achievements of Actively Controlled Divertor Detachment Compatible with Sustained High Confinement Core in DIII-D and EAST

Characterizations of Power Loads on Divertor Targets for Type-I, Compound and Small ELMs in the EAST Superconducting Tokamak

Progress of Physics Understanding for Long Pulse High-Performance Plasmas on EAST Towards the Steady-State Operation of ITER and CFETR