Abstract:Functionally graded insulation (FGI), which has a spatially non-uniform distribution of permittivity and/or conductivity, has been verified to be advantageous in better electric field distribution and enhanced insulation strength. To address the challenge of practical application of FGI (including the uncertainties of permittivity/conductivity distribution and difficulties in grading structure fabrication), periodical lattice material (PLM) can be employed due to its accuracy in properties and simplicity in fabrication. In this paper, the lattice-type composites with three-dimensional periodic truss structure were used for the construction of FGI, and the gradient distribution of relative permittivity was realized through structural adjustments of lattice unit cells. Based on previous research, this paper specifically focused on exploring the improvement of surface electrical strength and mechanical strength. Using the combined process of 3D printing and vacuum casting, lattice graded insulators and ISO-standard mechanical testing bars were prepared. The results of flashover voltage (FOV) test demonstrate that, compared with the original insulator, the lattice graded insulator achieves a surface FOV improvement of $14.6 \%, 57.8 \%$, and 48.3% in 0.1 MPa air, C4F7N/CO2, and SF6, respectively. Moreover, three-point bending strength of lattice structure is higher than both the truss lattice and filling material, demonstrating the enhancement of mechanical strength by the optimization of internal structures. This research indicates that PLM based functionally graded structure can be advantageous in both electrical and mechanical properties, providing a novel and practical solution for industrial employment of FGI components.

Surface Insulation Performance of 3D Printed Functionally Graded Insulator Fabricated by Active-Mixing Fused Deposition Modeling (AM-FDM)

3D printing fabrication of conductivity non-uniform insulator for surface flashover mitigation

3D Printing and Flashover Voltage Test of Polypropylene-based Dielectric Functionally Graded Insulator

Application of Functionally Graded Materials for Solid Insulator: Fabrication, Optimization Design, and Surface Flashover of Prototype Samples

Functionally Graded Insulator with Periodical Lattice Structures Enabling High Insulation and Mechanical Strength

Simulation Design and 3D-Printing Fabrication of Conductivity Graded Insulator

Numerical Optimization and 3D-Printing Fabrication Concept of High Voltage FGM Insulator

Topology optimization and 3D-printing fabrication feasibility of high voltage FGM insulator

Multi-dimensional Functionally Graded Insulator for HVDC Compact Gas Insulated Apparatus

Research Progress on Dielectric Functionally Graded Materials for Electrical Insulation

Characterization of Polypropylene/Titatium Dioxide Composites Used for 3D Printing of Dielectric Functionally Graded Insulators

Fabrication of Multidimensional Functionally Graded Insulator for HVDC GIS

Dielectrically Graded Photocurable Nanocomposite Coating for Achieving Enhanced Surface Insulation and Long-Term Stability

Construction of Permittivity-Graded Insulator Using Topology-Optimized Lattice Structure

Analysis Of Morphology And Electrical Insulation Of 3d Printing Parts

Grading of electric field distribution of AC polymeric outdoor insulators using field grading material

Dielectrically Graded Insulation Using Lattice Material: Concept and Numerical Exemplification

Multi-material and parameter-controllable stereolithography 3D printing of graded permittivity composites for high voltage insulators

Design and 3D printing of porous cavity insulation structure for ultra‐high electrical withstanding capability

Integrated Manufacturing and Performance Study of Continuous Functionally Graded Materials-Structures Based on Multi-Material 3D Printing and Constraint Sacrifice Layer

Optimal Design of Functionally Graded Power Cable Joint Utilizing Silicone Rubber/Carbon Nanotube Composites