Abstract:The Euler–Lagrange method is a great way for multiphase bubble flow simulation, the detailed information of bubbles can be effortlessly obtained, and it is helpful for the efficiency and safety of different industry processes. Traditionally, the computational fluid dynamics-discrete bubble model (CFD-DBM) method has always been used to simulate this flow process. Nevertheless, the ability of the traditional CFD-DBM method is significantly limited in terms of the size ratio between the grid and bubble, where the grid size must be larger than the bubble size. In reality, the bubble may be larger than the grid and the grid/bubble size ratio can be very large due to the effects of complex bubble dynamics (such as the bubble breakup and coalescence) and complex internal flows. To address this issue, an improved CFD-DBM method is proposed in this study, which can be used for the simulation with a wide grid/bubble size ratio in gas–liquid–bubble multiphase simulation, and the volume of fluid (VOF) method is applied to capture the interface between gas and liquid phases. A gradient-based interpolation method is employed to reconstruct the liquid velocity around the target bubble when the grid size is much larger than the bubble size. If the bubble size is comparable with or larger than the grid size, the interphase force correction and the field smoothing will be carried out within a spherical support area. Subsequently, the proposed model is validated by the comparison with a bubble column experiment, in terms of the bubble size distribution and bubble vertical velocity. The results demonstrate the high accuracy of the new method. Finally, the influence of different parameters including normal spring stiffness, critical Weber number, and the range of the spherical support area on the bubble flow is investigated.

A Two Fluid Modeling Study of Bubble Collapse Due to Bubble Interaction in a Fluidized Bed

Interaction of Two In-Line Bubbles of Equal Size Rising in Viscous Liquid

Novel Bubble–Emulsion Hydrodynamic Model for Gas–Solid Bubbling Fluidized Beds

Novel Phase Inversion Model for Gas–solid Turbulent Fluidized Beds

Dynamic Modelling of Fluidisation in Gas-Solid Bubbling Fluidised Beds

Experimental Investigation of the Behaviors of Highly Deformed Bubbles Produced by Coaxial Coalescence

Evolution and Interaction Characteristics of Liquid Flow and Bubbles in a Jet Bubbling Column

Modeling Agglomeration Behavior in High Temperature Gas–Solid Fluidized Beds Via Monte Carlo Method

Comparison of Two-Fluid Model Simulations of Freely Bubbling Three-Dimensional Gas-Fluidized Beds with Magnetic Resonance Imaging Results

Comparison of CFD-DEM and TFM Simulations of Single Bubble Injection in 3D Gas-Fluidized Beds with MRI Results

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Trial 2D Simulation of Microbubble Interaction Based on Multi-Scale Multiphase Flow Equation(Fluids Engineering)

Dynamics of Bubble Formation in Highly Viscous Liquid in Co-Flowing Microfluidic Device

Bubble Behavior in Gas–solid Bubbling Fluidized Beds Based on EMMS Model: Comparison of 2D, Q2D, and 3D Simulations

Fundamental Numerical Simulation of Microbubble Interaction Using Multi-scale Multiphase Flow Equation

Fundamental Study of Microbubble Coalescences Based on Multi-Scale Multiphase Flow Equations(Fluids Engineering)

Coalescence of Two Equal-Sized Bubbles with Air Injection

558 A study on numerical bubble-interaction model in micro-bubbly flows

Particle-scale Simulation of Fluidized Bed with Immersed Tubes

Interaction of Two Spark Generated Bubbles Beneath Free Surface

Flowrate Effects on the Lateral Coalescence of Two Growing Bubbles