Abstract:Zinc oxide (ZnO) varistors, which are produced by sintering ZnO powder together with small additives of Bi2O3, Co3O4, Sb2O3 and other oxides, are popular ceramic semiconductor devices and widely used in electric circuits and systems as voltage-clamping or surge-arrester owing to their extremely nonlinear current–voltage characteristics. The reliability of ZnO varistors is the most important consideration, and researches are mainly focus on the material properties of ZnO body and the effects of additives, such as ZnO grain size and the surrounding additive-rich insulating barriers. However, the manufacturing of electrodes still remains the traditional silver baking process, and few people investigate the effects of electrodes on the reliability of devices. In this paper, we propose a novel electrodes manufacture process using magnetron sputtering technology, and investigate the reliability of devices comparing to silver baking process. Two groups of samples with diameters of 20mm were prepared by silver baking and magnetron sputtering process respectively. The nonlinear voltage, nonlinear coefficient, and leakage current parameters were measured by the metal oxide varistor meter typed TTK-168; the energy absorption capacities were measured by a lightning current surge generator with 8/20μs impulse waves; the adhesive strength of electrodes was measured by a dynamometer; the microstructures of the samples were examined using Scanning Electron Microscope, and the change ratio of nonlinear voltages at an environment of 125°C after 100h was chosen as the main reliability parameter. Results show that the sputtered electrodes could improve the reliability of samples by reducing the change ratio from 1.32% to 0.61%, with other parameters exceeding the silver baking samples at the same time. This enhancement is benefit from the good interface between sputtered electrodes and ZnO substrate as well as the low temperature during magnetron sputtering process.

Comparison with the Influence of Different Types of Impulse Currents on the Degradation of Zinc-oxide Varistors

Statistical Investigation on the Electrical Responses of ZnO-based Varistors to Different Impulse Currents

The impulse current degradation of ZnO varistor ceramics

Effect of Impulse Current Degradation on the Electrical Properties and Dielectric Relaxations of ZnO-based Ceramic Varistors

A New View on Impulse Degradation of ZnO-based Ceramics

Research on Electronic Process of Impulse Degradation of ZnO-based Ceramics

Statistical Pulse Degradation Characteristics of Grain Boundaries in a ZnO Varistor Based on Microcontact Measurement

Effect of additive particle size on degradation behavior of ZnO varistors under high current surges

The Degradation of Silicone Rubber Composites with ZnO Microvaristors under Impulse Voltage

The Effect of DC degradation and heat-treatment on defects in ZnO varistor

Failure Modes of ZnO-based Varistor

Effect of Repeated Pulses of 8/20 Waveform on Power Frequency Voltage Withstand Capacity of ZnO Varistors

Harmonic Characteristics Of Leakage Currents Of Zno Varistors Under Impulse Aging

DC Degradation of ZnO Varistor and Its Restorability by Heat-Treatment

Analysis of Dynamic Voltage Current Characteristics of ZnO Varistors under 8/20 Μs Impulse Current

Indication Of Initial Degradation Of Zno Varistor Ceramics

Research progress of degradation mechanism of ZnO varistors

Study on the Decrease of Power Loss During DC Degradation of Zinc Oxide Varistor Ceramics

Stable Electrical Properties of ZnO Varistor Ceramics with Multiple Additives Against the AC Accelerated Aging Process

The Degradation of Epoxy Resin-Coated ZnO Varistors at Elevated Temperatures and Ambient Humidity Conditions

Reliability enhancement of zinc oxide varistors using sputtered silver electrodes.