Abstract:The turbulent flow discharging under a sluice gate is one kind of typical flows with complicated boundaries in hydraulic and hydroelectric engineering, and the characteristics of its flow field and flow evolution are important in engineering hydraulics. Although there were many studies in this regard, which mainly focus on the discharge capacity, the local scour and the mean flow field, some issues remain to be further investigated, for example, the variation of the mechanical energy during the scouring process, and the adjustment of the unsteady turbulent flow after the local scour with the downstream steady uniform flow. In this paper, the turbulent flow behind a sluice gate is divided into a rapidly varied flow region and a gradually varied flow region, and the above problems are investigated by theoretical analysis and numerical simulation. The main conclusions are as follows:(1) In the discharging process of the turbulent flow under a sluice gate, the river bed would be scoured continuously and the water–air interface is adjusted accordingly, which leads to a decrease of the mechanical energy of the total flow in the rapidly varied flow region, and the mechanical energy loss would also decrease with the increase of the time, yet the variation of the flow discharge under the sluice gate is very small.(2) In the link between the rapidly varied flow and the uniform flow downstream, the mean wall shear stress and the coefficient for the mechanical energy loss would decrease in the longitudinal direction, the decay of the turbulent kinetic energy near the free surface is much more significant than that near the bed in the longitudinal direction, and the mean turbulent kinetic energy in the section would decrease in the longitudinal direction and the decreasing rate is smaller than that of the mean wall shear stress.

Numerical simulation of dynamic flow around wicket gate in hydro turbine with guide vane closure

A Simulation Study of Hydraulic Vibration caused by Clearance Flow in a Pump Turbine

Transient Simulation Of Hydropower Station With Consideration Of Three-Dimensional Unsteady Flow In Turbine

Turbulence simulation and experimental study on new 3D wicket gate of francis turbine

Numerical simulation of turbulent flow behind sluice gate under submerged discharge conditions

Numerical Simulation of Flow Characteristics of Pump Turbine with Small Guide Vanes Opening

Transient simulation of turbine jointed with diversion penstock

Unsteady Turbulent Simulation of Three Gorges Hydraulic Turbine and Analysis of Pressure in the Whole Passage

Unsteady Turbulent Simulation of Prototype Hydraulic Turbine and Analysis of Pressure Fluctuation in Draft Tube

Transient Flow Dynamics Analysis of a Large Prototype Francis Turbine at Different Loads

Numerical simulation of free-surface flow in updraft-free-exit-flow hydropower turbine

Advances in CFD flow simulations for pump-turbine

NUMERICAL SIMULATION OF 3D VISCOUS FLOW IN THE HIGH-PRESSURE VALVE OF A 600MW STEAMTURBINE

Numerical simulation prediction of pressure distribution of guide vanes in a high-head pump turbine

EXPERIMENTAL STUDY AND NUMERICAL SIMULATION OF FLOW-INDUCED VIBRATION FOR THE HYDRAULIC STEEL RADIAL-GATE

Simulation of Unsteady Flow Induced by in Vortices the Draft Tube of a Francis Turbine

Transient Simulation of the Hydropower Station with Impulse Water Turbine

Numerical Analysis of Unsteady Flow under High‐head Operating Conditions in Francis Turbine

Numerical Simulation of the Transient Flow in a Pump-Turbine During the Load Rejection Process With Special Emphasis on the Cavitation Effect

Numerical Simulation of 3D Flow in a Turbine Cascade at Large Incidence

Dynamic hydraulic characteristics of a prototype ball valve during closing process analysed by 3D CFD method