Abstract:The magnitudes and distributions of the pressures around a tunnel lining are the most significant variables in shield tunnel design, as they determine the safety of the lining structure and influence the investment cost of the tunnel project. The grouting process has a negligible effect on the pressures exerted on the shield tunnel segmental linings when the boring machine is drilling. However, improper grouting control might result in large bending moments, local damage of segments and leakage at joints, leading to a reduction of the linings' safety, durability and serviceability. On the other hand, more and more special-section shield tunnels are developed to solve the problems associated with infrastructure construction under complex environmental conditions. How-ever, previous studies on the pressure distribution around tunnel linings all focused on circular tunnels. Few research about the loads during construction on special-section shield tunnels was conducted. In this study, three in-situ monitoring tests for the total pressure distributions of shallow buried quasi-rectangular tunnels in soft soils were carried out, which is deemed to be the first field study for special-section shield tunnels. Different grouting situations were adopted and the temporal and spatial distributions of the lining pressures during and after the construction were obtained. When the lining segments are pushed out of the shield tail, the adverse pressure distributions caused by grout ejections were observed which are typical non-uniform and unsymmet-rical. The effect of different grouting situations attenuates quickly in the longitudinal direction within a range of 9 rings. Additionally, the influence of the following back-up equipment and transportation carriages on the pressures outside the linings were first observed and studied by means of these field tests. The outside pressures fluctuated in different stages with the coincident pace of construction activities and performed as a counterforce and to resist the inside loads, which was different from the active loads exerted on the lining when the segmental rings were pushed out. From the long-term perspective, the pressure distributions in different tests tend to stabilize at a similar state. The influence of the grouting process or other construction loads on the lining pressures needed about 50 days to be relieved. A comparison between the measured results and the theoretical long-term pressures was conducted and the applicability of the proposed load distributions in the design model for quasi-rectangular tunnels was demonstrated. Additionally, a pressure mode combining cosinusoidal pressures and theoretical long-term pressures is proposed to predict the grouting pressures when lining segments are pushed out of the shield.

Evaluation of earth pressure around a deeply buried metro shield tunnel with a large cross-section under high water pressure conditions

Observed response of a shield-driven tunnel to fluctuations in river stage

STUDY OF GROUND HEAVE AND SUBSIDENCE INDUCED BY SHIELD TUNNELLING IN SOFT GROUND

Earth Pressure and Internal Forces of Tunnel Lining in Jet Grouting Reinforced Mud Stratum

Supporting Pressure for Earth Pressure Balance Tunnel Face Stability when Tunneling is Implemented in Saturated Sandy Soil

Investigation of the Pressure Distributions Around Quasi-Rectangular Shield Tunnels in Soft Soils with a Shallow Overburden: A Field Study

Observed Ground Pressure Acting on the Lining of a Large-Diameter Shield Tunnel in Sandy Stratum under High Water Pressure

In-Situ Monitoring Of Earth Pressures Upon Large Shield Tunnel With Small Overburden

Pressures on the Lining of A Large Shield Tunnel with A Small Overburden: A Case Study

Analysis of Superimposed Stress of Surrounding Soil Due to Shield Tunneling

Measurement of earth pressure of shallow buried tunnel with super large diameter and applicability evaluation of calculation method

Full-Scale Experimental Study on the Effect of Ground Surcharge on the Stress and Deformation of Shield Tunnels

Approach to Earth Balance Pressure of Shield Tunneling Across Ultra-Near Metro Tunnel in Operation

Reverse Calculation and Analysis of Measured Internal Force of Deeply Buried Shield Tunnels with Large Cross-section Under High Water Pressure Conditions

Study Of Distribution Law Of Earth Pressure Acting On Shield Tunnel Lining Based On In-Situ Data

Soil Stress of Shield Tunnel Face in Sands under High Hydraulic Pressure

Integrated Waterproofing Evaluation Method for Longitudinal Joints of Shield Tunnel Subjected to Extreme Surcharge: Numerical Analysis and Experimental Validation

Study on the Stability and Seepage Characteristics of Underwater Shield Tunnels under High Water Pressure Seepage

Nonlinear Analytical Solution of Earth Pressure on Shield Tunnel Linings Considering Ground Volume Loss

Field Testing Study of Mechanical Behaviors of Lining Structure of Large-Diameter Metro Shield Tunnel in Soft Soil Ground in Operation Phase

Model test on the behavior of tunnel linings under earth pressure conditions and external water pressure