Abstract:Although Toyoura sand has been widely used as a standard material for physical model tests (particularly centrifuge model tests), its path-dependent stiffness degradation curves are rarely reported in the literature. This leads to difficulties in back-analyzing and understanding the physical tests involving significant changes in the direction of stress paths (such as unloading problems). In this study, path-dependent stiffness degradation curves of medium-dense Toyoura sand were determined by carrying out a series of stress-path triaxial tests, with local strain measurements. In the triaxial tests, four typical recent stress histories (changes of path direction = 0, 90, -90, and 180 degrees) were simulated. The measured small strain stiffnesses of Toyoura sand were then used to calibrate an advanced hypoplastic model that accounts for path-dependent soil stiffness at small strains. To justify the validity of the calibrated hypoplastic model and model parameters, a Type A numerical prediction and a centrifuge model test were carried out to simulate a typical unloading problem (i.e., excavation) in medium-dense Toyoura sand. Triaxial test results show that a 180 degrees reversal in the direction of the stress path increased the initial secant modulus of Toyoura sand by eight times. The path dependency of soil stiffness, however, vanished when the deviatoric strain exceeded 0.3%. The ground deformations (resulting from excavation) predicted by the numerical analysis show reasonable agreement with the measured data from the centrifuge test. This suggests the potential applicability of the calibrated soil model and its model parameters in predicting or back-analyzing other physical model tests in Toyoura sand.

Simulation of non-coaxial characteristics of sandy soil based on state-dependent constitutive model

Non-coaxial hypoplastic model for sand with evolving fabric anisotropy including non-proportional loading

J2-deformation-type Soil Model Coupled with State-Dependent Dilatancy and Fabric Evolution: Multiaxial Formulation and FEM Implementation

Hypoplastic Modeling of Anisotropic Sand Behavior Accounting for Rotation of Principal Stress Direction

Hypoplastic Model for Sand under Multidirectional Shearing Conditions Considering Fabric Change Effect

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

Thermodynamics-based bounding surface model for overconsolidated clay

Unified Modeling of the Influence of Consolidation Conditions on Monotonic Soil Response Considering Fabric Evolution

Constitutive Modeling of Physical Properties of Coastal Sand During Tunneling Construction Disturbance

Effect Of Non-Coaxiality On Dilatancy Of Sand Involving Principal Stress Axes Rotation

A Hypoplastic Model for Granular Soils Incorporating Anisotropic Critical State Theory

Coulomb-Cam Model for Dilatancy and Work-Softening of Sand

A unified monotonic model for sand based on modified hyperbolic equation and state-dependent dilatancy

Constitutive modeling for cyclic responses of saturated soft clay under principal stress rotation induced by wave loads

Small Strain Path-Dependent Stiffness of Toyoura Sand: Laboratory Measurement and Numerical Implementation

Undrained Anisotropy and Non-Coaxial Behavior of Clayey Soil under Principal Stress Rotation

Constitutive model for soil with strain-softening behavior and its application in boundary value problems

A Thermodynamic Constitutive Model for Saturated Sand

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

The mechanisms of non-coaxial deformation for anisotropic sand under fixed principal stress axes shearing

A Thermodynamic Constitutive Model for Undrained Monotonic and Cyclic Shear Behavior of Saturated Soils