Abstract:Tunnel boring machine (TBM) is the preferred method in the construction of long-distance and deep-buried tunnel due to its advantages in safety and high efficiency. However, the TBM method is very sensitive to the condition of the surrounding rock. The strength and integrity characteristics of rock mass have great influence on the safe and efficient tunnelling. To provide a fast perception method for these characteristics during the TBM tunnelling process, an in-situ penetration testing system is proposed in the present study. The development and testing procedure of the system are elaborated. The system is applied to a TBM-excavated water conveyance tunnel to continuously perceive the strength and integrity characteristics of the surrounding rock. Firstly, the force-penetration (F-P) responses of the surrounding rock under penetration are qualitatively studied. Then, series of penetration indices are summarized to quantify the characteristics of the F-P responses. Finally, the quantitative relationships between the rock strength and the penetration indices are studied. The results indicate that the in-situ penetration testing system can perceive the rock mass strength and integrity characteristics qualitatively and quantitatively. On the qualitative aspect, the F-P responses can be categorized into four types (Type I to Type IV), which correspond to the level of rock mass strength and integrity. On the quantitative aspect, a single penetration index cannot represent the complete information of the F-P response. The descriptive classification of the rock mass strength (class I to III) is established through multiple penetration indices. The in-situ penetration testing system can be used as a method to quickly perceive the strength and integrity characteristics of the surrounding rock in TBM tunnelling.

Study and discussion on point load test for evaluating rock strength of TBM tunnel constructed in limestone

Case study: using the point load test to estimate rock strength of tunnels constructed by a tunnel boring machine

Study Of Surrounding Rock Damage Induced By Tunnel Boring Machine Driving Tunnel At West Route Of South To North Water Transfer Project

Study on the Tunneling Response of TBM in Stressed Granite Rock Mass in Yinhan Water Conveyance Tunnel

Experimental investigation of rock strength using indentation test and point load test

Reliability Analysis Of Measuring Strongly Weathered Grey Mudstone Strength With Point Load Measurement

In Situ TBM Penetration Tests and Rock Mass Boreability Analysis in Hard Rock Tunnels

EXPERIMENTAL STUDY OF TBM PENETRATION IN MARBLE ROCK MASS UNDER HIGH GEOSTRESS

Study on rock mass boreability by TBM penetration test under different in situ stress conditions

Fast perception of rock mass strength and integrity in TBM tunnelling using in-situ penetration test

A case study of TBM performance prediction using field tunnelling tests in limestone strata

A Review of Rock Boreability Testing for TBM Tunnelling

Linear cutting tests on effect of confining stress on rock fragmentation by TBM cutter

Experimental Study on Penetration Failure of Soft-Hard Interbedded Rock Mass under a Wedge

Prediction and Classification of Rock Mass Boreability in TBM Tunnel

LABORATORY STUDY OF DEFORMATION AND FAILURE OF SOFT ROCK FOR DEEP GROUND TUNNELLING WITH TBM

Influence of in-situ stress on rock fragmentation by TBM cutters and prediction of TBM performance for deep tunnels

Experimental Study of the Mechanism of TBM Disk Cutter Penetration in Mixed-Faced Grounds under Confining Pressure

Correlation Analysis of Machine Performance Parameters and Rock Mass Properties During Tunnel Boring Machine Excavation Process: A Case Study in Yin-song Headrace Tunnel, China

Rock burst and slabbing failure and its influence on TBM excavation at headrace tunnels in Jinping II hydropower station

Evaluation of rock muck using image analysis and its application in the TBM tunneling