Abstract:Purpose – Rock-fill dams are embankments of compacted free-draining granular earth containing an impervious zone. Earth utilized in such dams often contains a high percentage of large particles – hence the term rock-fill. Mass stability of these dams results from friction and particle interactions rather than through a cementing agent binding the particles together. However, high-stress conditions and prolonged exposure to the elements can severely damage rock-fill. Therefore, understanding and modeling rock-fill breakage is important for dam engineering. The purpose of this paper is to improve discontinuous deformation analysis (DDA) techniques for modeling rock-fill breakage, proving the new method using simulations of spherical particle crushing. Design/methodology/approach – This work models rock-fill as bonded ellipsoid particles, and develops an improved DDA method to model the breakage of particle assemblies. The paper starts by describing the principles of three-dimensional DDA for spherical particles, and then derives the submatrices for normal contact, shear contact, and frictional force. The new algorithm incorporates a bond model with a revised open-close iteration algorithm into the DDA method to simulate particle crushing. To validate the improved DDA method, calculated particle contacts and movements are validated against theoretical results. Finally, this work performs a series of point-loading experimental tests for cement ellipsoid particles of both high and low compression strengths, with the test results compared against the results from corresponding DDA simulations. Findings – In particle crushing tests, the force and displacement show an approximately linear relationship until the crushing point, at which point low compression ellipsoid particles split into several large pieces while the high-compression particles break into many small fragments. The DDA simulation results are in good agreement with the crushing tests, demonstrating the validity of the DDA method for solving particle crushing problems. Although the improved DDA model is applicable to rock-fill particle crushing studies, some issues remain, particularly in increasing calculation efficiency and performing large-scale computations and long real-time simulations. Future research should address these issues. Originality/value – A bond model with a revised open-close iteration algorithm is incorporated into the DDA method. The simulated results shed insight into rock-fill crushing mechanisms, an element of concern in engineering practices.

Influences Of Stress Paths And Saturation On Particle Breakage Of Rockfill Materials

Particle breakage of ultra-high dam rockfills under drained shearing

DEM SIMULATION OF WETTING DEFORMATION CHARACTERISTICS OF ROCKFILL CONSIDERING PARTICLE BREAKAGE

Dem Study on the Effect of Particle Breakage on the Macro- and Micro-Behavior of Rockfill Sheared along Different Stress Paths

A Large Triaxial Investigation of the Stress-Path-dependent Behavior of Compacted Rockfill

Influence Of Stress Path On Secant Modulus Of Soft Saturated Clay

Experimental study of the characteristics of wetting deformation of rockfill materials

Experimental Study of Deformation Characteristics of Rockfill under Different Environmental Conditions

Experimental investigation on stress-induced failure in D-shaped hard rock tunnel under water-bearing and true triaxial compression conditions

An Empirical Model For The Wetting Deformation Of Rockfill

Experimental investigation of statistical characteristics of elastic mechanical parameters and strength indexes of rockfill particles

Effective Stress Law for Rock Masses and Its Application in Impoundment Analysis Based on Deformation Reinforcement Theory

Experimental Investigation on the Influence of Water on Rockburst in Rock-like Material with Voids and Multiple Fractures

Particle Crushing Simulations with Improved Discontinuous Deformation Analysis

Particle mechanics modeling of creep behavior of rockfill materials under dry and wet conditions

DEM Simulation of Shearing Rockfills along Different Stress Paths

Analyzing the Energy and Damage Constitutive of Cemented Backfill with Different Water Content under Dynamic Load

DEM Simulation of the Behavior of Rockfill Sheared with Different Intermediate Principle Stress Ratios

Experimental study on the influence of intermediate principal stress on failure characteristics of strain rock burst for granite

Particle Flow Simulation of Failure Characteristics of Deep Rock Influenced by Sample Height-to-Width Ratios and Initial Stress Level under True-Triaxial Unloading

Triaxial numerical simulation study on the mechanical properties of rockfill materials under different boundary conditions