Abstract:Purpose – Rock-fill dams are embankments of compacted free-draining granular earth containing an impervious zone. Earth utilized in such dams often contains a high percentage of large particles – hence the term rock-fill. Mass stability of these dams results from friction and particle interactions rather than through a cementing agent binding the particles together. However, high-stress conditions and prolonged exposure to the elements can severely damage rock-fill. Therefore, understanding and modeling rock-fill breakage is important for dam engineering. The purpose of this paper is to improve discontinuous deformation analysis (DDA) techniques for modeling rock-fill breakage, proving the new method using simulations of spherical particle crushing. Design/methodology/approach – This work models rock-fill as bonded ellipsoid particles, and develops an improved DDA method to model the breakage of particle assemblies. The paper starts by describing the principles of three-dimensional DDA for spherical particles, and then derives the submatrices for normal contact, shear contact, and frictional force. The new algorithm incorporates a bond model with a revised open-close iteration algorithm into the DDA method to simulate particle crushing. To validate the improved DDA method, calculated particle contacts and movements are validated against theoretical results. Finally, this work performs a series of point-loading experimental tests for cement ellipsoid particles of both high and low compression strengths, with the test results compared against the results from corresponding DDA simulations. Findings – In particle crushing tests, the force and displacement show an approximately linear relationship until the crushing point, at which point low compression ellipsoid particles split into several large pieces while the high-compression particles break into many small fragments. The DDA simulation results are in good agreement with the crushing tests, demonstrating the validity of the DDA method for solving particle crushing problems. Although the improved DDA model is applicable to rock-fill particle crushing studies, some issues remain, particularly in increasing calculation efficiency and performing large-scale computations and long real-time simulations. Future research should address these issues. Originality/value – A bond model with a revised open-close iteration algorithm is incorporated into the DDA method. The simulated results shed insight into rock-fill crushing mechanisms, an element of concern in engineering practices.

Particle breakage of ultra-high dam rockfills under drained shearing

Particle breakage and gradation evolution of rockfill materials during triaxial shearing based on the breakage energy

Experimental Study On Particle Breakage Of Carbonate Gravels Under Cyclic Loadings Through Large-Scale Triaxial Tests

Mechanical behavior and particle breakage of calcareous sand in triaxial test

Particle Breakage of Argillaceous Siltstone Subjected to Stresses and Weathering

Dem Study on the Effect of Particle Breakage on the Macro- and Micro-Behavior of Rockfill Sheared along Different Stress Paths

Breakage behavior of silica sands during high-pressure triaxial loading using X-ray microtomography

Experimental investigation of statistical characteristics of elastic mechanical parameters and strength indexes of rockfill particles

DEM studies on the effect of particle breakage on the critical state behaviours of granular soils under undrained shear conditions

DEM Simulation of Shearing Rockfills along Different Stress Paths

Particle Crushing Simulations with Improved Discontinuous Deformation Analysis

Three-dimensional discrete element simulation of random breaking strength and size effect in single particle splitting test of rockfll

Particle Flow Simulation of Failure Characteristics of Deep Rock Influenced by Sample Height-to-Width Ratios and Initial Stress Level under True-Triaxial Unloading

Particle breakage energy and stress dilatancy in drained shear of rockfills

DEM SIMULATION OF WETTING DEFORMATION CHARACTERISTICS OF ROCKFILL CONSIDERING PARTICLE BREAKAGE

Characteristics of particle breakage and constitutive model of coarse granular material incorporating gradation evolution

DEM Simulation of the Behavior of Rockfill Sheared with Different Intermediate Principle Stress Ratios

Characteristics of particle breakage of sand in triaxial shear

Particle breakage and shape analysis of calcareous sand under consolidated-undrained triaxial shear

Particle breakage evolution of coral sand using triaxial compression tests

Nonlinear Mechanical and 3D Rupture Morphology of Saturated Porous Sandstone Under True Triaxial Stress