Abstract:A new nine‐level boost inverter with quadruple boost and self‐balanced capacitors is proposed. The inverter is suitable for renewable energy and industrial applications. In the work shown, a thorough analysis of the converter in both stand‐alone and grid‐connected modes is carried out. Reliability analysis and comparison with other converters is done. The working of the converter is verified through experimental, simulation, and hardware‐in‐loop results. Summary An increase in generation from distributed energy sources like solar PV has motivated researchers to explore better electrical energy conversion solutions. Multilevel inverters with fewer component count and boosting capabilities contribute to a reliable and efficient single‐stage solution. This work proposes a reliable single‐source switched capacitor multilevel inverter capable of producing nine‐level boosted AC voltage with its stand‐alone and grid‐connected operation. It employs 11 switches, three diodes, and three switched capacitors. The main feature of the proposed topology is its ability to produce quadruple boosting with respect to the DC input voltage. Another advantage is the exhibition of low capacitor currents due to frequent charging durations in one operational cycle. The selection criterion for the switched capacitors is also presented. The topology's performance is evaluated in MATLAB/Simulink under various conditions and in PLECS environments for its efficiency. It was then realized on an experimental prototype in stand‐alone mode. The topology is then modified in terms of topology and modulation to mitigate the leakage current, thus making it suitable for grid‐connected operation. This operation is validated on the hardware‐in‐the‐loop platform. Further, the reliability analysis explores a high total mean time to failure (MTTFT) of nearly 253,164 hours/failures compared to recent switched capacitor topologies and an efficiency of above 95%. The low inrush currents, high MTTFT value, and better efficiency make it a suitable topology for renewable microgrids' stand‐alone and grid‐integrated operation.

A Five-Level Common-Ground-T-Type Inverter for Solar Photovoltaic Applications

A Six-Switch Seven-Level Triple-Boost Inverter

A Novel Single-Stage Five-Level Common-Ground-Boost-Type Active Neutral-Point-Clamped (5L-CGBT-ANPC) Inverter

A five-level (5-L) double gain inverter for grid-connected and photovoltaic applications

Efficiency Improvement of 2- and 3-Level Inverters for Distributed Photovoltaic Application Using Hybrid Devices

Common-Ground-Type Single-Source High Step-Up Cascaded Multilevel Inverter for Transformerless PV Applications

A Single-Phase Common-Ground Five-Level Transformerless Inverter with Low Component Count for PV Applications

Common-Ground-Type Inverter with Dynamic Boosting and Reactive Compensation for Grid

General Control Scheme for a Dual-Input Three-Level Inverter

Boost-type common-ground PV inverter based on quasi-Z-source and switched-capacitor

A Three-Phase Five-Level Inverter With High DC Voltage Utilization and Self-Balancing Capacity of Floating Capacitor

Common-Ground-Type Inverter Topology With Low Voltage Stress and Boosting Ability

Neutral-Point-Clamped Five-Level Inverter With Self-Balanced Switched Capacitor

A Modular Multilevel Converter with Boosting, Self-Balancing, and Scaling Capabilities for High- Voltage Transformerless PV Applications

New boost type single phase inverters for photovoltaic applications with reduced device count

A five‐level single‐phase transformerless inverter with lesser component count for PV applications

High performance of three-level T-type grid-connected photovoltaic inverter system with three-level boost maximum power point tracking converter

A Common Ground Switched Capacitor Multilevel Inverter (SCMLI) with A Low Components Count

A Novel Single-Phase Asymmetrical Five-Level Transformerless Photovoltaic Inverter

A single‐source nine‐level solar‐PV inverter with quadruple voltage boosting and high reliability

A new seven level boost-type ANPC inverter topology for photovoltaic applications