Abstract:We are developing the Laser Guide Star Adaptive Optics (LGS/AO188) system for the Subaru Telescope at Mauna Kea, Hawaii. This system utilizes a combination of an all-solid-state mode-locked sum-frequency generation (SFG) laser (1.7-GHz bandwidth, 0.7-ns pulse width) as a light source and a single-mode optical fiber for beam transference. However, optical fibers induce nonlinear effects, especially self-phase modulation (SPM). We studied SPM in our photonic crystal fiber (PCF). SPM broadens the spectrum of a laser beam and decrease the efficiency of bright laser guide star generation. We measured the spectrum width using a spectrum analyzer. We found a spectrum width of 8.4 GHz at full width at half maximum (FWHM). The original FWHM of our laser spectrum was 1.4 GHz. This was equivalent to a 70 % loss in laser energy. We also measured the brightness of the sodium cell and evaluated its performance as a function of laser wavelength. The cell's brightness showed a peculiar tendency; specifically, it did not extinguish even though the wavelength varied by more than 5 pm. To reduce the impact of SPM, we developed an optical system that divides one laser pulse into four lower-power pulses. The laser peak power after passing through the new optical system was decreased to one-fourth the original, reducing the impact of SPM on the sodium cell. An actual laser guide star created with the new system was 0.41 mag brighter than the laser guide star created with the original system. We achieved brighter laser guide star generation by dividing a laser pulse to reduce its peak intensity. This is an effective method for laser relay using optical fiber.

A method to suppress the distortion of light spot during power

Smoothing of Small On-Target Spots Produced by Frequency-Tripled Beams Using Lens Array and Spectral Dispersion

Effects of Polarization and Phase Modulation on the Focal Spot in 4pi Microscopy

A Focal Spot with Variable Intensity Distribution for Optical Tweezers

Uniform irradiation of adjustable target spots in high-power laser driver.

Spatial-Temporal Distortions And Calibration Of Ultrashort Pulses In Complex Optical Systems

Method to Improve Beam Quality by Compensating Spherical Aberrations in Master Oscillator Power Amplifier Laser Systems

Optimization of Longitudinal Alignment of an 4<i>f</i> System in a Compact Vectorial Optical-Field Generator Based on a High-Resolution Liquid Crystal Spatial Light Modulator

Compensation of Dispersion-Induced Power Fading with Adjustment-Free Operation

A novel small-scale self-focusing suppression method for ultrahigh peak power lasers

Ghost Analysis of the Terminal Optical System in High Power Laser Set

Verification and analysis of stray light in high-power laser system

Analysis Of Nonlinear Self-Focusing Phenomenon In High-Power Laser System Based On Ray-Tracing

Focal Spot Effects on the Generation of Proton Beams During Target Normal Sheath Acceleration

Influence of Bragg Reflection of Chirped Tilted Fiber Bragg Grating on Raman Suppression in High-Power Tandem Pumping Fiber Amplifiers.

Superposition- and interference-induced optical spectrum distortion in the figure-9 fiber laser

Effective suppression of mode distortion induced by stimulated Raman scattering in high-power fiber amplifiers

Suppressing the Amplified Spontaneous Emission in the High-Power 1018-Nm Monolithic Fiber Laser by Decreasing the Feedback from the Inner Reflections

A 4.8-kW high-efficiency 1050-nm monolithic fiber laser amplifier employing a pump-sharing structure

Suppresion of Self-Phase Modulation in a Laser Transfer System using Optical Fiber on the Subaru Telescope

Power Enhancement and Spot Homogenization Design for Arrayed Semiconductor Lasers