Abstract:Perforated plates/liners have been widely applied in aeroengines and gas turbines to dissipate unwanted noise. In this work, numerical simulations and experimental study of acoustic damping performance of single-layer perforated plates are conducted. For this, a frequency-domain numerical model is developed via solving 3-dimensional Helmholtz equations. The model validation is performed first by evaluating and comparing the calculated acoustic damping performances of three perforated plates with the experimental results available in literature. These plates are perforated with a number of circle-shaped orifices, which have different porosities σ. Each plate backed by a resonant cavity is placed at the end of a rectangular-shaped pipe with a loudspeaker implemented on the other end. To simulate real engines, a mean flow (also known as bias flow) is applied to pass through the perforated orifices. The effects of 1) the mean flow Mach number Ma, 2) the resonance parameter Q, 3) the porosity σ and 4) the plate thickness T are studied one at a time. Acoustic damping performance of these plates is characterized by using sound absorption coefficient α and specific acoustic impedance z. It is found that sound absorption coefficient α is increased first and then decreased with increased Ma. The real part of z characterizing acoustic resistance/damping is linearly increased, as Ma is increased. However, the imaginary part of z characterizing acoustic reactance remains almost unchanged. It is also found that the presence of the bias flow greatly increases the maximum sound absorption coefficient αmax by approximately 33% in comparison with that of without mean flow. The plate thickness T is shown to shift the frequency corresponding to the maximum sound absorption coefficient. Comparing the present simulation results with the experimental and analytical ones available in the literature reveals that good agreement is obtained at lower frequency range. However, as frequency is increased, the model predicts that the bias flow leads to the local αmax reduced by 15%. The plate with a larger thickness is associated with another local αmax, which is not observed for a lower thickness plate. Finally, experimental measurements of the acoustic damping of 2 single-layer in-duct perforated plates are performed. The frequency-domain model is then applied to simulate the experiment. Good agreement between our experimental and numerical results is obtained.

Attenuation Effects of Perforated Plates with Heterogeneously Distributed Holes on Combustion Instability in a Spray Flame Combustor

Mitigating Self-Excited Thermoacoustic Oscillations in a Liquid Fuel Combustor Using Dual Perforated Plates.

Application of the Perforated Plate in Passive Control of the Nonpremixed Swirl Combustion Instability under Acoustic Excitation

Passive Suppression of Self-Excited Combustion Instabilities in Liquid Spray Flame Using Microperforated Plate

TEST STUDY ON OUTLET FLOW FIELD PERFORMANCE FROM WAVE-SHAPED COMBUSTION-STABILIZING BODY OF THE CONCENTRATION TUNABLE RICH/LEAN BURNERS

Experimental Investigation on High Frequency Perturbation to Combustion Instability by Low Frequency Actuator in a Backward-facing Step Combustor

Influence of perforated plate thickness on supersonic combustion wave propagation mechanism in a stoichiometric H2-O2 mixture

Control of thermoacoustic instability of liquid-spray flame with porous sound absorber

Experimental and Frequency-Domain Study of Acoustic Damping of Single-Layer Perforated Plates

Combustion Instability Control Performance of an Improved Helmholtz Resonator in the Presence of Bias Flow

The behaviors of supersonic combustion wave through a perforated plate in a stoichiometric mixtures of H2/CH4/O2 and H2/O2

Modeling analysis of combustion instability in an annular combustor equipped with circumferentially segmented perforated liner

Experimental study of perforated-wall rotating detonation combustors

Experimental Study on the Mid-Frequency Sound Absorption Performance of Multiple Aperture Dual Perforated Plates Traversed by Bias Flow

Study on sound pressure level and acoustic damping ratio of one dimensional sound field partitioned by perforated plate with geometric similarity

An Experimental Investigation on Explosion Behaviors of Syngas-Air Mixtures in a Vessel with a Large Blockage Ratio Perforated Plate

Study of Burner Geometry Effects on Non-Premixed Flame Response under Acoustic Excitation

Experimental Studies of Mitigating Premixed Flame-Excited Thermoacoustic Oscillations in T-shaped Combustor Using an Electrical Heater

Combustion Characteristics and Radiation Performance of Premixed Hydrogen/air Combustion in a Mesoscale Divergent Porous Media Combustor

A Numerical Study on Non-Premixed H2/air Flame Stability in a Micro-Combustor with a Slotted Bluff-Body

Effect of Solid Material on the Blow-Off Limit of Ch4/Air Flames in A Micro Combustor with A Plate Flame Holder and Preheating Channels