Assessment of the effectiveness of stall delay and tip loss corrections for the simulation of small propeller performance with Virtual Blade Model
Lorenzo Stabeli Diehl,José Gustavo Coelho
DOI: https://doi.org/10.1016/j.euromechflu.2023.12.013
IF: 2.598
2024-01-07
European Journal of Mechanics - B/Fluids
Abstract:The powertrain efficiency of most small unmanned air vehicles (SUAVs) depend on the aerodynamic performance of multiple propellers, which must be modelled before its optimisation. To predict propeller performance while capturing interaction effects not accountable for by momentum theories, the Virtual Blade Model (VBM) can be used at much lower costs than conventional Computational Fluid Dynamics (CFD). However, the accuracy of VBM depends on aerofoil polar data that often misrepresent rotational and three-dimensional effects that influence small propellers. In an attempt to expand the capabilities of VBM, it is a common practice to introduce correction models for aerofoil coefficients in its formulation, but the actual effectiveness of such approach for small propeller analysis remains unassessed. In this paper, VBM in OpenFOAM was extended with stall delay and tip loss models, while aerodynamic databases at low Reynolds numbers were built with XFOIL and extrapolated to the full angle of attack range. The accuracy of three VBM versions was validated against wind tunnel measurements of two off-the-shelf small propellers. For the lower-pitch propeller, thrust and power at low advance ratios and efficiency at high advance ratios were significantly improved by the stall delay model. But for the higher-pitch propeller, thrust and power were overpredicted with extended versions of VBM under most operating conditions, which is attributable to an excessive shift of effective angles of attack to the post-stall region by the stall delay model and to uncertainties in extrapolated polar data. The results suggest that without reliable procedures for obtaining polar data, correction models should be implemented in VBM only for the simulation of low-pitch propellers operating at low advance ratios, given their avoidance of the effective angle of attack range where XFOIL and extrapolation methods are mainly expected to fail in predicting lift behaviour.
mechanics,physics, fluids & plasmas