Abstract:Understanding the heat transfer of winglet tips is crucial for their applications in high pressure turbines. The current paper investigates the heat transfer performance of three different winglet-cavity tips in a transonic turbine cascade at a tip gap of 2.1% chord. A cavity tip was studied as the baseline case. The cascade operates at engine representative conditions of an exit Mach number of 1.2 and an exit Reynolds number of 1.7×106. Transient infrared thermography technique was used to obtain the tip distributions of heat transfer coefficient for different tips in the experiment. The CFD results were validated with the measured tip heat transfer coefficients, and then used to explain the flow physics related to heat transfer. It is found that on the pressure side winglet, the flow reattaches on the top winglet surface and results in high heat transfer coefficient. On the suction side winglet, the heat transfer coefficient is low near the blade leading edge, but is higher from the mid-chord to the trailing edge. The suction side winglet pushes the tip leakage vortex further away from the blade suction surface and reduces the heat transfer coefficient from 85% to 96% span on the blade suction surface. However, the heat transfer coefficient is higher for the winglet tips from 96% span to the tip. This is because the tip leakage vortex attaches on the side surface of the suction side winglet and results in quite high heat transfer coefficient on the front protrusive part of the winglet. The effects of relative endwall motion between the blade tip and the casing were investigated by CFD methods. The endwall motion has a significant effect on the flow physics within the tip gap and near tip region in the blade passage, thus affects the heat transfer coefficient distributions. With relative endwall motion, a scraping vortex forms inside the tip gap and near the casing, and the cavity vortex gets closer to the pressure side squealer/winglet. The tip leakage vortex in the blade passage becomes closer to the blade suction surface, resulting in an increase of the heat transfer coefficient.

Influence of the Reynolds Number on Transonic Tip Flow

Effect of Tip Clearance on the Heat Transfer and Pressure Drop Performance in the Micro-Reactor with Micro-Pin–fin Arrays at Low Reynolds Number

Impact of Inlet Flow Angle Variation on the Performance of a Transonic Compressor Blade Using NIPC

Roughness Effects on Flow Losses of a High-Lift Low-Pressure Turbine Cascade

Experimental study on the rapid establishment of the transonic gap flow field

Numerical Study of Tip Leakage Vortex Around a NACA0009 Hydrofoil

Experimental and Computational Assessment into the Heat Transfer for the Blade Multicavity Tips

Numerical study on the Re effects on the tip flow structures of transonic fan under inlet distortion

Aerothermal Performance of Different Tips in Transonic Turbine Cascade with End-Wall Motion

Numerical Simulation Of A Transonic Centrifugal Compressor Blades Tip Clearance Flow Of Vehicle Turbocharger

Numerical investigation of the unsteady tip leakage flow and rotating stall inception in a transonic compressor

Heat Transfer of Winglet Tips in a Transonic Turbine Cascade

Numerical investigation on the influence of nonuniform tip clearance on rotor tip-clearance flow field structure

Effect of in-service burnout on the transonic tip leakage flows over flat tip model

Blade Aerodynamic Force and Tip Region Vortex Spatial-temporal Evolution Study of a Compressor Cascade

Numerical Investigation on the Originating Mechanism of Unsteadiness in Tip Leakage Flow for a Transonic Fan Rotor

Wing-tip vortex dynamics at moderate Reynolds numbers

Numerical investigation into rotating instability and the vortex structure near the tip in a transonic compressor rotor

Numerical Investigation on Ultra-High-lift Low-Pressure Turbine Cascade Aerodynamics at Low Reynolds Numbers Using Transition-Based Turbulence Models

Tip Gap Size Effects on Thermal Performance of Cavity-Winglet Tips in Transonic Turbine Cascade with Endwall Motion

Lock-in effect of over-tip shock waves and identification of the escaping vortex-shedding mode in pressure-driven tip leakage flow