Design and Fabrication of Spinel Nanocomposites Derived from Perovskite Hydroxides As Gas Sensing Layer for Volatile Organic Compounds Detection

Kuan Tian,Wenhui Zhang,Su-Ning Sun,Lu Xing,Zi-Yuan Li,Tong-Tong Zhang,Niu-Niu Yang,Bei-Bei Kuang,Hua-Yao Li
DOI: https://doi.org/10.1016/j.snb.2020.129076
IF: 9.221
2020-01-01
Sensors and Actuators B Chemical
Abstract:The spinel oxides are identified as the highly promising materials for gas sensing application due to their good thermal stability, low cost and nice sensitivity. The spinel oxide nanocomposites of Co3O4/SnO2 and Co2SnO4/SnO2 were prepared by the co-precipitation method, and their gas sensing characteristics were investigated in this work. Compared with the Co3O4/SnO2 nanocomposites, the sensor based on Co2SnO4/SnO2 nanocomposites exhibited significantly enhanced response and selectivity performance toward triethylamine (TEA). The response of the Co2SnO4/SnO2 composites is about 45.9 to 100 ppm TEA at 270 degrees C, which was almost 4 times higher than that of Co3O4/SnO2 nanocomposites. The excellent performance of the Co2SnO4/SnO2 composites can be attributed to the catalytic ability of divalent Co2+ cation located in octahedral sites in spinel structure, which results in enhanced gas absorption and catalytic performance.
What problem does this paper attempt to address?