Effect of Adding Brush on the Bottom of the Ice-Valve-sealed Pressure-Retaining Device on Ice Formation Speed

Moke Lian,Jianming Peng,Chaoyang Huang,Yanliang Li,Guang Zhang
DOI: https://doi.org/10.1016/j.applthermaleng.2020.116269
IF: 6.4
2020-01-01
Applied Thermal Engineering
Abstract:The ice-seal holding-pressure technology has attracted more and more attention for it does not have the disadvantages of traditional mechanical seals, therefore, its applications are more and more extensive. To make better use of the ice valve, the influence of setting different porosity on the formation rate of the ice valve and the optimization of its pressure-holding performance was discussed. The creative point is to use a brush as the blocking medium to obstruct the natural convection, the calculation parameters of the brush were set at the bottom of the ice valve tube by the porous media model in CFD software Fluent to investigate the different laws of ice valve formation under different porosity conditions, and compare the calculation results with laboratory test results. The results show that with the decrease of the fluid porosity at the bottom of the ice valve tube, the natural convection strength and the loss of cooling capacity are correspondingly reduced, and the formation time is consistent with the laboratory test. The ice valve will be formed in the porous medium area in advance, which could further reduce the formation time of the ice valve 5-7 min, and avoid the unfrozen situation at the center of the ice valve tube after a long time under no-brush condition.
What problem does this paper attempt to address?