Abstract:We focus on the parameter identification of doubly fed induction generator （DFIG} based wind turbine generator （WTG）. Firstly, the trajectory sensitivity analysis is used to make judgments about the identifiability of parameters. If the phases of sensitivity curves are not the same or reverse, the parameters are uniquely identifiable. By this theory, we find that the stator reactance and rotor reactance cannot be simultaneously identified, but the other parameters are uniquely identifiable. Secondly, the difficulty of identification which means the possibility of obtaining the accurate values o{ the parameters from the measurement data is analyzed. A parameter is easy to be identified if the sensitivities of both time-domain and frequency-domain are high. A parameter which has a high value only in the low frequency area of the frequency-domain sensitivity curve is relatively easy to be identified. It is found that the stator reactance, rotor reactance, and exciting reactance are easy to be identified; the stator resistance and rotor resistance are relatively easy to he identified; the inertial constant is difficult to be identified. According to the analysis of identifiability and the difficulty of identification, four key parameters including the stator resistance, stator reactance, exciting reactance, and rotor resistance are decided to be identified. Then, an ant colony optimization algorithm based identification method is designed. Finally, the correctness of the analysis and the efficiency of the identification method are validated by the simulation results obtained in Matlab/Simulink environment.

Control Parameter Identification in Grid-side Converter of Directly Driven Wind Turbine Systems

Parameter Identification Method for Converter Controller of DFIG Based on Measurement Signal Disturbance

Model parameter identification of DFIG based on short circuit current

Parameter identification of drive system for fixed-speed wind power generation units

Analysis on the Identification of Doubly Fed Induction Generator

Distinguishability Analysis of Controller Parameters with Applications to DFIG Based Wind Turbine

Parameter Identification of DFIG Converter Control System Based on WOA

Modeling Principle and Parameter Identification of Double Fed Wind Turbine for Electromechanical Transient Simulation of Power System

Stator Voltage Oriented Variable-parameter Control Strategy for Wind Turbine Driven Doubly Fed Induction Generator

Sensorless Control of PMSG for Wind Turbines Based on the On-Line Parameter Identification

A Controller Parameter Identification Method of PMSG-Based Wind Turbine Generator Based on Measured Impedance

Research on Direct-drive Wind Generation Power Converter Control Without PMSG Parameters

D-Q Axis Decoupling Parameter Identification Strategy for the Grid-Connected Inverter of Photovoltaic Generation System

Parameter Identification Of Inverter-Fed Induction Motors: A Review

A dq axis decoupling parameter identification strategy for grid connected inverter controller of photovoltaic generation system

System identification of individual pitch control wind turbine

Controller parameter identification of the grid connected PV inverter for fault transient modeling

Decoupling Estimation of Parameters in Rotor Side Controller of DFIG-based Wind Turbine by Frequency Domain Method

Identification of control parameters of the permanent magnetic synchronous generator using least square method

Parameter Identification of Controller for Photovoltaic Inverter Based on L-M Method

Small-signal Analysis and Control System Parameter Optimization for DFIG Wind Turbines