Abstract:In addition to selective catalytic reduction (SCR) and selective non-catalytic reduction (SNCR) which are available to remove NO x from flue gas, oxidation method is receiving more and more attention because this method makes it possible to remove NO x and SO 2 from flue gas simultaneously by wet scrubbing. O 3 as a strong oxidant has a high oxidation capacity and it can oxide NO to N 2 O 5 which has a higher water solubility compared with NO 2 . However, it needs a long reaction time and the escape of unreacted ozone may cause secondary pollution. In this study, FeMnCo/Al 2 O 3 catalyst and FeMnCe/Al 2 O 3 catalyst were prepared and applied to enhance the deep oxidation of NO x with ozone and reduce O 3 slip. Effects of various operating parameters such as O 3 /NO ratio, gas residence time, and operating temperature were evaluated, and the results demonstrate that N 2 O 5 began to generate when O 3 /NO ratio was higher than 1.0 and increased with increasing O 3 /NO ratio. Little residual O 3 was formed in the presence of catalyst, while 350 ppm O 3 was measured at the outlet gas when O 3 /NO ratio was controlled at 2.0. The N 2 O 5 conversion efficiency increased with increasing gas residence time and operating temperature, and the highest N 2 O 5 conversion efficiency was achieved at 100°C. Furthermore, the conversion efficiency remained around 90% during 20 h operation over FeMnCe/Al 2 O 3 catalyst with an O 3 /NO ratio of 1.73, a gas residence time of 1.2 s, and a temperature of 100°C. On the other hand, the N 2 O 5 conversion efficiency remained around 80% during 3 h operation over FeMnCo/Al 2 O 3 catalyst. Overall, FeMnCe/Al 2 O 3 catalyst reveals good potential for deep oxidation of NO by O 3 and can be further developed as a viable catalyst for reducing NO emission from industries. Implications : In this study, FeMnCo/Al 2 O 3 catalyst and FeMnCe/Al 2 O 3 catalyst were applied to enhance the deep oxidation of NO into N 2 O 5 with O 3 . The catalysts can improve the conversion of NO into N 2 O 5 , shorten the reaction time and reduce the unreacted O 3 slip, which are beneficial to reduce the size of the reactor required and cost of APCDs (air pollution control devices) in practical application. This method can make it possible to simultaneously remove NO x and SO 2 from flue gas by wet scrubbing for reducing NO emissions from industries, especially small and medium scaled industries, to meet increasingly stringent emission standards.

Engineering Practice and Economic Analysis of Ozone Oxidation Wet Denitrification Technology

O3 oxidation combined with semi-dry method for simultaneous desulfurization and denitrification of sintering/pelletizing flue gas

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

Absorption of NOx from flue gas with alkaline aqueous solution combined with gas-phase oxidation of NO using ozone

Experimental study on three additives used for the removal of nitrite, a byproduct of ozone oxidation denitration technology

A Superior Liquid Phase Catalyst for Enhanced Absorption of NO2 Together with SO2 after Low Temperature Ozone Oxidation for Flue Gas Treatment

Investigation of NO Removal with Ozone Deep Oxidation in Na2CO3 Solution

Characteristics of O3 Oxidation for Simultaneous Desulfurization and Denitration with Limestone–Gypsum Wet Scrubbing: Application in a Carbon Black Drying Kiln Furnace

Experimental study on NOx emission characteristics under oxy-fuel combustion

Simultaneous Removal of SO2 and NO x Using Steel Slag Slurry Combined with Ozone Oxidation

O3 oxidation excited by yellow phosphorus emulsion coupling with red mud absorption for denitration

Experimental Research for the Simultaneous Removal of NOx and SO2 in Flue Gas by O3

Experimental Research for Multi-Pollution Control by Ozone and by-Product Purification

Wet Oxidation and Absorption Procedure for NOx Removal

Using Chlorine Dioxide to Remove NOx in Low-Temperature Flue Gas

Numerical evaluation of the effectiveness of NO2 and N2O5 generation during the NO ozonation process

Integration of removal of NOx in flue gas with ozone oxidation and surplus heat recovery of flue gas

Removal of NO and SO_2 from Flue Gas by Wet Scrubbing Using Aqueous NaClO Solution

Research on Simultaneous Desulfurization and Denitrification by Ozone Oxidation Integrated with Chemical Scrubber:Theoretical Analysis of SOx and NOx Absorption Properties of Limestone Slurry

NOx Reduction in a 130 T/h Biomass-Fired Circulating Fluid Bed Boiler Using Coupled Ozonation and Wet Absorption Technology

Deep oxidation of NO via catalytic ozonation