Abstract:Pressure and aeration measurements obtained under storm conditions on the steep-fronted masonry wall of a rubble-mound breakwater are analysed in detail, and the results compared with those obtained using a 1:4 scale freshwater model of the field test site. New insights are gained into the complex behaviour of the most violent impacts, with particular attention given to aeration and scale effects. The existence in the field of both low-aeration (LA) and high-aeration (HA) impacts is confirmed and new parameters introduced to facilitate further analysis. Maximum pressures (P max ) up to 771kPa are categorised and the magnitudes of the resultant impulses found to depend mainly on their durations. The alternate expansion and recompression (ERC) of air following a HA impact is shown to apply significant oscillatory pressures and forces to the wall. Information on the magnitude, period and damping of these oscillations is presented. The model results are initially scaled in accordance with the Froude law. In conditions comparable to those in the field, the highest pressure on the sloping wall is again found to occur in HA impacts with P max ≤ 3.17MPa followed by ERC oscillations. Like those in the field, the oscillations at different elevations tend to come into phase with each other and can subject the wall to oscillatory forces of significant vertical extent. Both the initial excursion and the damping of the oscillations tend be greater in the model than in the field. The maximum forces on the wall also tend to be greater than those on the field breakwater, but the durations of the impulses tend to be shorter. This apparent trade-off between force and duration may indicate that the model is responding differently to the momentum flux of the incoming waves. P max ≤ 5.42MPa are obtained when the model wall is vertical. Because the Froude law does not scale aeration effects correctly, model data are also scaled in accordance with the Bagnold-Mitsuyasu (B-M) law which increases the highest P max for the vertical wall to 20.97MPa. An alternative assessment of the ERC oscillations is also made on the assumption that the trapped-air pockets are geometrically similar to ones that could occur in the field. Likely generic characteristics of violent wave-impacts are identified as are probable model scale-effects. Impact-pressure reduction curves derived from a numerical model are presented to emphasise the influence of entrained air on wave loading. Further work is recommended.

Spatiotemporal Characteristics of the Dam-Break Induced Surge Pressure on a Vertical Wall

Numerical Simulation of Two-Dimensional Dam Failure and Free-Side Deformation Flow Studies

Physical processes explaining the second force peak generated during a surge impact on a vertical wall

A Comprehensive Study of the Impact Pressure Induced by a Single Cavitation Bubble Collapsing Near a Solid Wall

Experimental study on the dam-break-induced surge impact on an inclined wall

Impact of Multiphase Flow Simulation of Breaking Waves on a Vertical Seawall with a Recurved Parapet

Investigation of Water-Water Interface in Dam Break Flow with A Wet Bed

Modelling the impact of a dam‐break wave on a vertical wall

Numerical and Experimental Investigation of Three-Dimensionality in the Dam-Break Flow Against a Vertical Wall

Experimental study on microscopic characteristics of impinging spray at elevated ambient pressure conditions during development

Numerical Simulation To The Effect Of Air In Dam-Break Problem

Dynamic Interaction Between Valve-Closure Water Hammer Wave and Centrifugal Pump

Experimental Study on Wavefront Flow Characteristics of Dam-Break Wave at Initial Stage on Wet Bed

Building Performance in Dam-Break Flow – an Experimental Study

Comparative Study on Breaking Waves Interaction with Vertical Wall Retrofitted with Recurved Parapet in Small and Large Scale

Experiment and RANS modeling of solitary wave impact on a vertical wall mounted on a reef flat

Violent breaking-wave impacts. Part 4: A detailed analysis and comparison of field and 1:4 scale measurements on sloping and vertical walls including the influence of air and scale effects.

Experimental investigation of dynamic pressure loads during dam break

SPH simulations of 3D dam-break flow against various forms of the obstacle: Toward an optimal design

Experimental Research on the Dam-Break Mechanisms of the Jiadanwan Landslide Dam Triggered by the Wenchuan Earthquake in China

Jet development and impact load of underwater explosion bubble on solid wall