Research of deflector shape on hydrodynamic performances of double-slotted cambered otter-board
Lei WANG,Lu-min WANG,Chun-lei FENG,Xun ZHANG,Ai-zhong ZHOU,Yu ZHANG,Yong-li LIU,Guang-rui QI
DOI: https://doi.org/10.3969/j.issn.1004-2490.2017.06.010
2017-01-01
Marine Fisheries
Abstract:In order to improve the hydrodynamic performance of double-slotted cambered otter board by optimizing the deflector structure,the effect of the deflector shape of double-slotted cambered otter board on hydrodynamic performances was investigated by model wind tunnel test.Four deflector shapes were designed in otter-board models:rectangle,fan shape,convex trapezoid and concave trapezoid.The basic structural parameters of four otter-board models were the same,the aspect ratio was 2.5,the camber ratio was 12％,the angle of double-layer deflector was 30° and 25°,and the angle of main-panel was 12°.The otter-boards models were installed on the six-component mechanical tower-balance separately,and the test was conducted in wind tunnel with the flow velocity at 28 m · s-1 and the angle of attack α measured from 0° to 70° to obtain drag coefficients Cx,lift coefficient Cy,pressure-center coefficient Cp,calculated lift to drag ratio Cy/Cx and to give the relation curve of these values and angle of attack α.For comparison in the lift coefficient of four otter-board models,the results showed that the relationship of the maximum lift coefficient Cy between four otter-board models was Cy (convex trapezoid) ＞ Cy (rectangle) ＞ Cy (fan shape) ＞ Cy (concave trapezoid),the maximum lift coefficient Cy of the otter-board model with convex trapezoid structure was higher,it was 1.946 (α =47.5 °).For comparison in the drag coefficient of four otter-board models,the results showed that the relationship of the drag coefficient Cx between four otter-board models at the attack angel of 30°was Cx (fan shape) ＞ Cx (rectangle) ＞ Cx (concave trapezoid) ＞ Cx (convex trapezoid),the drag coefficient Cx of the otter-board model with convex trapezoid structure was lower.For comparison in the lift to drag ratio of four otter-board models,the results showed that the relationship of the maximum lift to drag ratio Cy/Cx between four otter-board models was C,/Cx (convex trapezoid) ＞ Cy/Cx (rectangle) ＞ Cy/Cx (fan shape) ＞ Cy/Cx (concave trapezoid),the maximum lift to drag ratio Cy/Cx of the otter-board model with convex trapezoid structure was higher,it was 7.486 (α =30°).In comparison of stability,the stability of otter board model with double fan deflector structure was better,and its lower absolute value of Cm and variable coefficient Cp were 0.061 and 5.43％ respectively.Therefore,the double-slotted cambered otter-board with convex trapezoidal deflector could provide larger lift and have good working effect,the double-slotted cambered otter-board with fan shaped deflector had the higher stability.The results would offer the reference for the structural optimization design of trawl otter board.