Abstract:In this paper, LiNi0.98Mn0.02O2 and LiNi0.95Mn0.05O2 binary materials were synthesized by chemical co-precipitation method. The phase characterization and electrochemical performance analysis of Ni-Mn binary materials were carried out by X-ray diffraction, scanning electron microscopy, transmission electron microscopy and electrochemical tests, and the action of Mn element on the material was studied. XRD analysis shows that LiNi0.95Mn0.05O2 material has the better layered structure (1.47 of the (003)/(104) peak intensity ratio), and the lower Li-Ni mixing ratio (1.98%). The initial discharge capacity of LiNi0.95Mn0.05O2 material at 1 C is 189.6 mAh/g, and the capacity retention rate is 89.93% after 100 cycles at 1 C, which is much higher than LiNiO2 of 177.4 mAh/g and 60.26%. In addition, the initial discharge specific capacity of LiNi0.95Mn0.05O2 can reach 205.8 mAh/g at 0.5 C under the high temperature of 50 °C, and the capacity retention rate is 78.7% at 0.5 C for 100 cycles, while the discharge specific capacity of LiNiO2 is 191.1 mAh/g at 0.5 C and the capacity retention rate is only 63.9%. Excellent electrochemical properties of Ni-Mn materials than LiNiO2 at room and high temperature is because Mn4+ without electrochemical activity is stabilized in the transition metal layer during the charge and discharge process of the materials, alleviating the structural collapse caused by the Li/Ni mixing. By comparing the cross-section of the materials before and after 100 cycles at 1 C, LiNi0.95Mn0.05O2 has fewer microcracks due to the high reversible phase transformation of H2-H3 according to the analysis of the dQ/dV versus voltage curves. Meanwhile, the stable layered structure and lithium-ion diffusion channel also make LiNi0.95Mn0.05O2 has the better lithium-ion conductivity.

Exploring the Synthesis Conditions and Formation Mechanisms of Li-rich Layered Oxides Via Solid-State Method

Radially Oriented Single‐Crystal Primary Nanosheets Enable Ultrahigh Rate and Cycling Properties of LiNi0.8Co0.1Mn0.1O2 Cathode Material for Lithium‐Ion Batteries

Synthesis and Electrochemical Characteristics of Li₁.₂(Ni₀.₂Mn₀.₆)ₓ(Co₀.₄Mn₀.₄)y(Ni₀.₄Mn₀.₄)₁₋ₓ₋yO₂ (0 ≤ X + Y ≤ 1) Cathode Materials for Lithium Ion Batteries

Bio-inspired synthesis of xLi2MnO3-(1 − x)LiNi0.33Co0.33Mn0.33O2 lithium-rich layered cathode materials

Preparation of Single-Crystal Li-Rich Mn-Based Layered Oxides with Excellent Electrochemical Performance via Simple Stepwise High-Temperature Sintering

Design of a new Li-rich Mn-based ternary cathode material based on Ni, Co, and Mn action mechanism

Temperature-controlled direct dry synthesis of Co-Ni free cathode materials 0.7Li2MnO3·0.3LiFeO2 for lithium-ion batteries

Exploit Li 2 MnO 3 activity by two phase coexistence at atomic level towards high performance Mn-based Co-free Li-rich cathodes

Tuning Li2MnO3-Like Domain Size and Surface Structure Enables Highly Stabilized Li-Rich Layered Oxide Cathodes.

A novel calcination method towards layered Ni-rich cathode with enhanced electrochemical performances and regulated oxygen vacancies

Improved solid-state synthesis and electrochemical properties of LiNi0.6Mn0.2Co0.2O2 cathode materials for lithium-ion batteries

High-Performance Lithium-Rich Layered Oxide Material: Effects of Preparation Methods on Microstructure and Electrochemical Properties

Rational Synthesis of High-Performance Ni-rich Layered Oxide Cathode Enabled Via Probing Solid-State Lithiation Evolution

Facile Synthesis and Enhanced Electrochemical Performances of Li2tio3-Coated Lithium-Rich Layered Li1.13ni0.30mn0.57o2 Cathode Materials for Lithium-Ion Batteries

Chemical and structural evolution during solid-state synthesis of cobalt-free nickel-rich layered oxide cathode

Effect of Co/Mn content on electrochemical properties of Ni-rich LiNi0.9CoxMn0.1-xO2

Synthesis, Characterization and Electrochemical Performance of Li[Li0.2Mn0.54Ni0.13Co0.13]O2cathode Materials for Lithium-Ion Batteries

Synthesis and characterization of Nickel-rich layered LiNi1-xMnxO2 (x=0.02,0.05) cathodes for lithium-ion batteries

Reinforcing the Stability of Cobalt-free Lithium-rich Layered Oxides via Li-poor Ni-rich Surface Transformation

Preparation of layered LiNi1/3Co1/3-xLaxMn1/3O2 as cathode material by oxalate co-precipitation method

Structural evolution and formation mechanism of LiNi0.6Co0.2Mn0.2O2 during high-temperature solid-state synthesis