Abstract:Since early 1990s lithium-ion batteries (LIBs) have become the most important secondary/rechargeable battery technology for portable electronic devices; and more recently for battery powered vehicles. Extensive research has been conducted on high-capacity electrode materials for LIBs due to the emerging demands for high energy density batteries for electric vehicles. Compared with the conventional cationic redox-based cathode materials, such as NMC, LMO and LFP, Li-excess, Manganese rich layered cathode (LLC) materials containing cationic and anionic redox process, show great potential as the next generation cathode materials because of their higher theoretical specific capacity and lower raw material cost. Our work has shown that Ni content of the Co-free, LLC materials, Li 1.2 Ni x Mn 0.8-x O 2 (x = 0.12, 0.24, 0.30 and 0.36) prepared by a citric acid method, has a significant impact on the material structure, electrochemical performance, and thermal stabilities. Generally, the primary particle size increased as the Ni content increased with a primary particle size distribution in the range of 200–600 nm for the samples investigated. Monoclinic phase (C2/m) and spinel (Fd3m) phase depending on the content of Ni have been identified by XRD. With increasing Ni content, the fraction of the spinel phase decreased and eventually the pure layered structure was obtained on the samples at x = 0.30 and 0.36. Our work demonstrates that the charging and discharging capacities are determined by the Ni or Mn content. The highest charging and discharging capacities were achieved when x = 0.24. As Ni content increased, the first cycle coulombic efficiency decreased, and the thermal stability deteriorated. But, an increase in Ni content results in an increase in average discharge voltage, higher electrochemical stability of the layered structure, fast Li ions diffusivity. Li 1.2 Ni 0.12 Mn 0.68 O 2 sample exhibited the best capacity retention and thermal stability among the tested samples. However, its specific energy density was limited due to the lowest average discharge voltage. The Li 1.2 Ni 0.36 Mn 0.44 O 2 sample which contained the highest Ni content exhibited the worst thermal stability, but relatively higher specific energy density due to the highest average discharge voltage.

Effect of Co/Mn content on electrochemical properties of Ni-rich LiNi0.9CoxMn0.1-xO2

Radially Oriented Single‐Crystal Primary Nanosheets Enable Ultrahigh Rate and Cycling Properties of LiNi0.8Co0.1Mn0.1O2 Cathode Material for Lithium‐Ion Batteries

Enhancing high-voltage performances of nickel-based cathode material via aluminum and progressive concentration gradient modification

Synthesis and Electrochemical Characteristics of Li₁.₂(Ni₀.₂Mn₀.₆)ₓ(Co₀.₄Mn₀.₄)y(Ni₀.₄Mn₀.₄)₁₋ₓ₋yO₂ (0 ≤ X + Y ≤ 1) Cathode Materials for Lithium Ion Batteries

Synergistic Effects of Ni 2+ and Mn 3+ on the Electrochemical Activation of Li 2 MnO 3 in Co-Free and Ni-Poor Li-Rich Layered Cathodes

Effects of Abundant Co Doping on the Structure and Electrochemical Characteristics of LiMn1.5Ni0.5−xCoxO4

Effect of Mn Doping on the Structure and Electrochemical Performance of LiNi0.7Co0.3O2

Impact of Ni Content on the Electrochemical Performance of the Co-Free, Li and Mn-Rich Layered Cathode Materials

Substantial Doping Engineering in Layered LiNi0.5+xCo0.2−xMn0.3O2 Materials for Lithium-Ion Batteries

Impact of Ni Content on the Structure and Electrochemical Performance of the Co-Free, Li/Mn-Rich Layered Cathode Materials

Substantial Doping Engineering in Layered LiNi 0.5+x Co 0.2−x Mn 0.3 O 2 Materials for Lithium-Ion Batteries

Enhancing the Electrochemical Performance and Structural Stability of Ni-Rich Layered Cathode Materials via Dual-Site Doping

Electrochemical Performance of Layer-Structured Ni0.8Co0.1Mn0.1O2 Cathode Active Materials Synthesized by Carbonate Co-Precipitation

Revealing Roles of Co and Ni in Mn‐Rich Layered Cathodes

Improvement of stability and capacity of Co-free, Li-rich layered oxide Li1.2Ni0.2Mn0.6O2 cathode material through defect control

Interphase Modification of Li(Ni0.5Co0.2Mn0.3)O2 Based Lithium Battery Electrode Materials by Depolarized and Pre-Lithiation for High Capacity and Cycling Performance

Design of a new Li-rich Mn-based ternary cathode material based on Ni, Co, and Mn action mechanism

Structural and Electrochemical Properties of Low-Cobalt-Content LiNi0.6+xCo0.2-xMn0.2O2 (0.0 ≤ X ≤ 0.1) Cathodes for Lithium-Ion Batteries.

Enhanced Electrochemical Performance of Ti-doped Li1.2Mn0.54Co0.13Ni0.13O2 for Lithium-Ion Batteries

Electrochemical performance and structural stability of layered Li–Ni–Co–Mn oxide cathode materials in different voltage ranges

High Performance Li[Li0.2Ni0.13Co0.13Mn0.54](BO4)0.75x(BO3)0.25xO2-3.75x Cathode with Polyanion for Li-Ion Batteries