Abstract:The safety of explosives is closely related to the stress state of the explosives. Under some stress stimulation, explosives may detonate abnormally. It is of great significance to accurately describe the mechanical response of explosives for the safety evaluation of explosives. The mechanical properties of polymer bonded explosives (PBXs) strongly depend on pressure. In this study, the mechanical behaviour of PBXs under confined conditions was investigated. It was found that the stress-plastic strain response of a PBX under high confining pressures is a combination of the non-linear and linear hardening portions. However, the linear hardening portion has often been neglected in characterizing the mechanical behaviour of a PBX under such pressures. The Karagozian and Case (K&C) model was applied to characterize the mechanical behaviour of PBXs. The numerical results demonstrated that when the confining pressure was high, the K&C model could not adequately match the experimental data due to the limitation of the damage model. Therefore, a new damage model was developed by means of considering intragranular damage and transgranular damage. This modification made it possible to introduce a linear hardening process into the original K&C model. The method proposed to describe the stress-strain results under high confining pressures was to consider the stress-plastic sa din curve, including the nonlinear and linear hardening portions. The damage evolution of the original K&C model and a linear hardening model were applied for the nonlinear and linear hardening portions respectively. The influence of the linear hardening model on the damage evolution of the original K&C model was included when describing the nonlinear hardening portion. A comparison between simulation and experiment showed that the modified K&C model could well describe the mechanical response of PBXs under different confining pressures.

Modeling of the deformation and damage of plastic-bonded explosive in consideration of pressure and strain rate effects

Numerical Simulations of the Damage Evolution for Plastic-Bonded Explosives Subjected to Complex Stress States

A Pressure-Dependent Plasticity Model for Polymer Bonded Explosives under Confined Conditions

Multiscale Modeling for Dynamic Compressive Behavior of Polymer Bonded Explosives

A Micromechanical Model for Predicting Combined Damage of Particles and Interface Debonding in PBX Explosives

Modelling Microstructural Deformation and the Failure Process of Plastic Bonded Explosives Using the Cohesive Zone Model

Characterization, Modeling and Simulation of the Impact Damage for Polymer Bonded Explosives

Numerical Mesoscopic Investigations of Dynamic Damage and Failure Mechanisms of Polymer Bonded Explosives

Damage Constitutive Model of PBX Explosive and Its Engineering Application

Numerical Simulations of Microcrack-Related Damage and Ignition Behavior of Mild-Impacted Polymer Bonded Explosives

Publisher Correction: A Viscoelastic–viscoplastic Constitutive Model for Polymer Bonded Explosives under Low Impact Loading

Mechanical Behavior of a Typical Polymer Bonded Explosive under Compressive Loads

A viscoelastic–viscoplastic constitutive model for polymer bonded explosives under low impact loading

Numerical Analysis of the Damage and Failure Behavior of Polymer-Bonded Explosives Using Discrete Element Method

Experimental and Numerical Investigation of Dynamic Damage and Load Transfer of PBX Substitute Material under Low Velocity Impact

Investigation on Fracture Behavior of Polymer-Bonded Explosives under Compression Using a Viscoelastic Phase-Field Fracture Method

Investigation into the Influences of SHPB Loading Ways on the Mechanical Response of PBX

Mechanical Property and Damage Evolution of Polymer-Bonded Explosive Substitute under Biaxial Compression

Microcrack and Microvoid Dominated Damage Behaviors for Polymer Bonded Explosives under Different Dynamic Loading Conditions

Experimental analysis and multi-scale simulation of the fracture behavior of polymer-bonded explosives based on the dynamic notched semi-circular bend method

The Dynamic Mechanical Behaviour and the Statistical Crack Mechanics Model for a Polymer-bonded Explosive