Abstract:The safety of explosives is closely related to the stress state of the explosives. Under some stress stimulation, explosives may detonate abnormally. It is of great significance to accurately describe the mechanical response of explosives for the safety evaluation of explosives. The mechanical properties of polymer bonded explosives (PBXs) strongly depend on pressure. In this study, the mechanical behaviour of PBXs under confined conditions was investigated. It was found that the stress-plastic strain response of a PBX under high confining pressures is a combination of the non-linear and linear hardening portions. However, the linear hardening portion has often been neglected in characterizing the mechanical behaviour of a PBX under such pressures. The Karagozian and Case (K&C) model was applied to characterize the mechanical behaviour of PBXs. The numerical results demonstrated that when the confining pressure was high, the K&C model could not adequately match the experimental data due to the limitation of the damage model. Therefore, a new damage model was developed by means of considering intragranular damage and transgranular damage. This modification made it possible to introduce a linear hardening process into the original K&C model. The method proposed to describe the stress-strain results under high confining pressures was to consider the stress-plastic sa din curve, including the nonlinear and linear hardening portions. The damage evolution of the original K&C model and a linear hardening model were applied for the nonlinear and linear hardening portions respectively. The influence of the linear hardening model on the damage evolution of the original K&C model was included when describing the nonlinear hardening portion. A comparison between simulation and experiment showed that the modified K&C model could well describe the mechanical response of PBXs under different confining pressures.

Mechanical Property and Damage Evolution of Polymer-Bonded Explosive Substitute under Biaxial Compression

Mechanical Behavior of a Typical Polymer Bonded Explosive under Compressive Loads

Deformation and Failure of Polymer Bonded Explosives under Diametric Compression Test

Experimental Study on the Localized Deformation and Damage Behavior of Polymer-Bonded Explosive Simulant under Cyclic Compression

Microstructure, deformation and failure of polymer bonded explosives

Compressive Behavior and Damage Evaluation of a PBX Substitute Material

Dynamic Compressive Properties of Polymer Bonded Explosives under Confining Pressure

Deformation, fracture and mechanical properties of PBX under dynamic loading by using digital speckle correlation method

Experimental and Numerical Investigation of Dynamic Damage and Load Transfer of PBX Substitute Material under Low Velocity Impact

Numerical Analysis of the Damage and Failure Behavior of Polymer-Bonded Explosives Using Discrete Element Method

Study on Fracture Behaviour of a Polymer‐Bonded Explosive Simulant Subjected to Uniaxial Compression Using Digital Image Correlation Method

Multiscale Modeling for Dynamic Compressive Behavior of Polymer Bonded Explosives

Study on Compression–expansion Behaviour of PBXs Substitutive Materials

Mechanical Behavior of a PBX Substitute Material under Static and Dynamic Loading

Investigating the Dynamic Compressive and Tensile Properties of Polymer Binder Explosive Based on the Split-Hopkinson Bar Technique

Fracture behavior of PBX simulation subject to combined thermal and mechanical loads

A Pressure-Dependent Plasticity Model for Polymer Bonded Explosives under Confined Conditions

Investigation on Fracture Behavior of Polymer-Bonded Explosives under Compression Using a Viscoelastic Phase-Field Fracture Method

Investigation into the Influences of SHPB Loading Ways on the Mechanical Response of PBX

A Micromechanical Model for Predicting Combined Damage of Particles and Interface Debonding in PBX Explosives

On the Tension-Induced Microcracks' Nucleation in a PBX Substitute Material under Impact Compression Loading