Abstract:AC pulse heating is a promising preheating method for lithium-ion batteries due to its low energy cost and high efficiency. To avoid the lithium plating in the AC heating, upper bound of heating current (UBHC) should be obtained. In this paper, the dual RC model is developed, and coupled with the thermal model to predict the battery temperature and potential of negative electrode (PNE). PNE = 0 V is used as the lithium plating criteria. If the PNE falls to 0 V during the heating process, the lithium plating is triggered, and the corresponding pulse amplitude is the UBHC. Moreover, because the UBHC increases with the battery temperature, the pulse amplitude should be automatically raised to increase the heating efficiency. When the battery temperature is too low, the UBHC is so small that the AC pulse heating is inapplicable. Through the self-adaptive AC pulse based on the UBHC, the heat strategy is built, and the heating time is calculated. The total heating time reached by the proposed strategy increases with the increment of the initial SOC, and it falls with the decrease of the initial battery temperature. Moreover, the heating time has a temperature limit. If the battery temperature is lower than the limit, the battery cannot be heated to the target temperature in the required time. The proposed strategy is applied to heating the battery at the different SOCs, and its performance is compared to the constant amplitude pulse. In the same heating time, the battery temperature achieved by the proposed strategy is at least 7.6 °C higher than the constant amplitude pulse. Moreover, the UBHC is enlarged by 10% to prove the original UBHC can reduce the degradation. The cyclic heating experiment shows that the 110% UBHC reaches a capacity loss of 0.49 Ah after 60 heating cycles and that of the original UBHC is only 0.1 Ah.

The Effect of Pulsed Current on the Performance of Lithium-ion Batteries

Study on Charging Characteristics of Li-ion Battery Using High-current Pulse Charging Method

Effect of Pulsed Current on Charging Performance of Lithium-Ion Batteries

A Review of Pulsed Current Technique for Lithium-ion Batteries

Lithium-Ion Battery Lifetime Extension with Positive Pulsed Current Charging

Lifetime Extension of Lithium-Ion Batteries with Low-Frequency Pulsed Current Charging

A rapid lithium-ion battery heating method based on bidirectional pulsed current: Heating effect and impact on battery life

Experimental study of the effect of different pulse charging patterns on lithium-ion battery charging

Investigating the Effect of Different Bidirectional Pulsed Current Parameters on the Heat Generation of Lithium-Ion Battery at Low Temperatures

Pulsed Current Boosts the Stability of the Lithium Metal Anode and the Improvement of Lithium-Oxygen Battery Performance

A Pulse Heating Method Without Capacity Reduction for Lithium-ion Batteries

Effects of Pulse Charging on the Performances of Lithium-Ion Batteries

Effects of pulsating flow on the performance of multi-channel cold plate for thermal management of lithium-ion battery pack

Analysis on Pulse Charging–discharging Strategies for Improving Capacity Retention Rates of Lithium-Ion Batteries

Experimental Study on Electrical Properties of Power Lithium-ion Battery

Effects of intermittent pulsating flow on the performance of multi-channel cold plate in electric vehicle lithium-ion battery pack

An Internal Heating Strategy for Lithium-Ion Batteries Without Lithium Plating Based on Self-Adaptive Alternating Current Pulse

Investigation of Lithium-Ion Battery Negative Pulsed Charging Strategy Using Non-Dominated Sorting Genetic Algorithm II

The Effect of Pulse Charging on Commercial Lithium Cobalt Oxide (LCO) Battery Characteristics

Optimal Charging Strategy With Complementary Pulse Current Control of Lithium-Ion Battery for Electric Vehicles

Effects of Different Charging and Discharging Modes on Thermal Behavior of Lithium Ion Batteries