Abstract:AC pulse heating is a promising preheating method for lithium-ion batteries due to its low energy cost and high efficiency. To avoid the lithium plating in the AC heating, upper bound of heating current (UBHC) should be obtained. In this paper, the dual RC model is developed, and coupled with the thermal model to predict the battery temperature and potential of negative electrode (PNE). PNE = 0 V is used as the lithium plating criteria. If the PNE falls to 0 V during the heating process, the lithium plating is triggered, and the corresponding pulse amplitude is the UBHC. Moreover, because the UBHC increases with the battery temperature, the pulse amplitude should be automatically raised to increase the heating efficiency. When the battery temperature is too low, the UBHC is so small that the AC pulse heating is inapplicable. Through the self-adaptive AC pulse based on the UBHC, the heat strategy is built, and the heating time is calculated. The total heating time reached by the proposed strategy increases with the increment of the initial SOC, and it falls with the decrease of the initial battery temperature. Moreover, the heating time has a temperature limit. If the battery temperature is lower than the limit, the battery cannot be heated to the target temperature in the required time. The proposed strategy is applied to heating the battery at the different SOCs, and its performance is compared to the constant amplitude pulse. In the same heating time, the battery temperature achieved by the proposed strategy is at least 7.6 °C higher than the constant amplitude pulse. Moreover, the UBHC is enlarged by 10% to prove the original UBHC can reduce the degradation. The cyclic heating experiment shows that the 110% UBHC reaches a capacity loss of 0.49 Ah after 60 heating cycles and that of the original UBHC is only 0.1 Ah.

A Pulse Heating Method Without Capacity Reduction for Lithium-ion Batteries

Study on Charging Characteristics of Li-ion Battery Using High-current Pulse Charging Method

A rapid lithium-ion battery heating method based on bidirectional pulsed current: Heating effect and impact on battery life

An Internal Heating Strategy for Lithium-Ion Batteries Without Lithium Plating Based on Self-Adaptive Alternating Current Pulse

Pulse self-heating strategy for low-temperature batteries based on bidirectional charging systems

Experimental study on pulse self–heating of lithium–ion battery at low temperature

Investigation of novel pulse preheating strategies for lithium-ion batteries at subzero temperature based on a multi-level CFD platform

The Effect of Pulsed Current on the Performance of Lithium-ion Batteries

Targeting the low-temperature performance degradation of lithium-ion batteries: a non-destructive bidirectional pulse current heating framework

An Adaptive Low-Temperature Mutual Pulse Heating Method Based on Multiplexing Converters for Power-Redistributable Lithium-Ion Battery Pack

Investigating the Effect of Different Bidirectional Pulsed Current Parameters on the Heat Generation of Lithium-Ion Battery at Low Temperatures

An optimized internal heating strategy based on bidirectional pulsed current for lithium-ion battery at low temperature

Safe bidirectional pulse heating method for the lithium-ion battery pack on a high-power electric motorcycle

An Optimal Pulse Heating Strategy for Lithium-ion Battery Considering both Capacity Fade and Heating Time

Experimental study on self-heating strategy of lithium-ion battery at low temperatures based on bidirectional pulse current

A health-aware AC heating strategy with lithium plating criterion for batteries at low temperatures

A Review of Pulsed Current Technique for Lithium-ion Batteries

A rapid self-heating strategy of lithium-ion battery at low temperatures based on bidirectional pulse current without external power

Analysis on Pulse Charging–discharging Strategies for Improving Capacity Retention Rates of Lithium-Ion Batteries

A Square Wave Alternating Current Preheating with High Applicability and Effectiveness of Preventing Lithium Plating

Temperature consistency–oriented rapid heating strategy combining pulsed operation and external thermal management for lithium-ion batteries