Abstract:The Ni-Fe-based superalloy GH4169 (Inconel718) is widely used for several critical gas-turbine components which are hot forged. Its microstructure and property are sensitive to the parameter adjustment during hot working process. To obtain required low-cycle fatigue and fracture properties, it is essential that the microstructure is controlled during preheating and heat treatment. The evolution of non-uniform microstructure during hot working is more complicated than that of uniform microstructure. On the other hand, various secondary phases can be observed in GH4169 alloy, thus it is important to investigate the effect of secondary phases on the microstructure evolution during forging process. In this work, the mechanisms of non-uniform microstructure evolution in GH4169 alloy were studied by analyzing the evolution of secondary phases, grain boundary misorientation, grain size and interactions of dislocation. It is found that the volume fraction of 8 phase increases with the increasing of temperature and heating time at the lower temperature. While at the higher temperature, it decreases monotonously with the temperature increasing, but increases first and then decreases to stable value with time increasing. The pinning effect of secondary phases in GH4169 alloy can be concluded that the gamma '' phase and 8 phase precipitated within the grains retain movement of dislocation, the 8 phase precipitated at the grain boundary hinders the nucleation and growth of recrystallized grains, and the carbides limits the grain growth. The frequency of low angle grain boundary decreases with temperature and time increasing, and the mobility of low angle grain boundary increases with temperature increasing. The uniformity of microstructure and the size of equaxied subgrain increases with heating temperature and time increasing. Continuous recrystallization of elongated grain occurs at specific conditions. The mechanisms of non-uniform microstructure evolution during heating process can be concluded as sub grain growth, recrystallized grain growth, and anneal twinning nucleation and growth. The recrystallized grains are formed by the growth of subgrains conducted by the rotation of low angle grain boundary and the movement of dislocation. When the grain growth is pinned, the mechanisms for the energy dissipation is the nucleation and growth of anneal twinning. And the growth of anneal twinning promotes the generation of low angle grain boundaries at the tip of partial anneal twinning.

Evolution mechanisms of recrystallized grains and twins during isothermal compression and subsequent solution treatment of GH4586 superalloy

Microstructure evolution and dynamic recrystallization mechanism during thermal deformation of GH4698 superalloy

Mechanisms of Non-Uniform Microstructure Evolution in Gh4169 Alloy During Heating Process

Kinetics and microstructural evolution during recrystallization of a single crystal superalloy

Thermal deformation behavior and dynamic recrystallization mechanism of GH4065A alloy considering the effect of γ′ phase

Study on the dynamic recrystallization mechanisms of GH5188 superalloy during hot compression deformation

Unraveling Dynamic Recrystallization Mechanisms in Ni-based Wrought Superalloy GH4698 Through Comprehensive EBSD Analysis

Hot Deformation Characteristics of GH141 Superalloy

Recrystallization Process of GH738 Alloy at Different Deformation Conditions

Discontinuous Dynamic Recrystallization Mechanism and Twinning Evolution during Hot Deformation of Incoloy 825

The Effect of Post-heat Treatment on the Microstructures of Single Crystal DD6 Superalloy

Dynamic Recrystallization Mechanism and Twinning Behavior in Hot Deformation of Ti-46.5Al-2Nb-2Cr with Initial Duplex Microstructure

EBSD Study of Grain Growth Behavior and Annealing Twin Evolution after Full Recrystallization in a Nickel-Based Superalloy

Thermal deformation behavior and microstructure evolution of GH4169 superalloy under the shear-compression deformation conditions

Microstructure and Microtexture Evolution of Dynamic Recrystallization of a Ni-based Superalloy under High-Throughput Gradient Thermal Compression

Microstructure Evolution and Dynamic Softening Mechanisms During High-Temperature Deformation of a Precipitate Hardening Ni-based Superalloy

Experimental Study and Numerical Simulation of Dynamic Recrystallization for a FGH96 Superalloy During Isothermal Compression

Microstructural Evolution on the Initiation of Sub-Solvus Recrystallization of A Grit-Blasted Single-Crystal Superalloy

Microstructure evolution in GH4742 superalloy by combining hot deformation and heat treatment

Investigation on Sub-Solvus Recrystallization Mechanisms in an Advanced γ-γ’ Nickel-Based Superalloy GH4151

Dynamic recrystallization mechanisms of as‐extruded GH4151 alloy during hot deformation