Abstract:In this study we synthesized LiFePO4/carbon/reduced graphene oxide (LFP/C/rGO) composite cathode materials using a method involving sol–gel processing, spray-drying, and calcination. To improve the electrochemical performance of LFP/C, we tested graphene oxides (GOs) of various morphologies as conductive additives, including pristine GO, three-dimensional GO, and hydrothermal porous GO (HTGO). Among our samples, the cathode material prepared through spray-drying with the addition of 1 wt% of HTGO (denoted SP-LFP/C/1%rHTGO) displayed the best electrochemical performance; its discharge capacities at 0.1C, 1C, 5C, and 10C were 160.5, 151.8, 138.8, and 130.3 mA h g−1, respectively. From measurements of its long-term cycling performance, the discharge capacity in the first cycle and the capacity retention after 30 cycles at 0.1C were 160.2 mA h g−1 and 99.6%, respectively; at 10C, these values were 132.2 mA h g−1 and 91.8%, respectively. The electronic conductivity of SP-LFP/C/1%rHTGO (6.58 × 10−5 S cm−1) was higher than that of the pristine LFP/C (9.24 × 10−6 S cm−1). The Li+ ion diffusivities (DLi+) of the SP-LFP/C/1%HTGO cathode, measured using AC impedance (3.91 × 10−13 cm2 s−1) and cyclic voltammetry (6.66 × 10−10 cm2 s−1 for discharge), were superior to those of the LFP/C cathode (9.31 × 10−15 cm2 s−1 and 1.79 × 10−10 cm2 s−1 for discharge, respectively). Galvanostatic intermittent titration revealed that the value of DLi+ was located in a reasonable range from 1 × 10−10 to 1 × 10−17 cm2 s−1; its value dropped to its lowest point when the state of charge was close to 50%. Thus, the use of spray-drying and the addition of conductive HTGO (having a 3D wrinkled morphology and interconnected pore structure) can enhance the electronic conductivity and Li+ ion diffusivity of LFP/C cathode materials, thereby improving the electrochemical performance significantly.

Construction of Submicron-Sized LiFe0.4Mn0.6PO4/C Enwrapped into Graphene Framework for Advanced Li-storage

Synergistic Ternary Composite (carbon/fe3 O4 @graphene) with Hollow Microspherical and Robust Structure for Li-Ion Storage.

Hierarchical MOF-derived Layered Fe3O4 QDs@C Imbedded on Graphene Sheets As a High-Performance Anode for Lithium-ion Storage

Synthesis of Hierarchical and Bridging Carbon-Coated LiMn0.9Fe0.1PO4 Nanostructure As Cathode Material with Improved Performance for Lithium Ion Battery

Synthesis and characterization of LiMn0.8Fe0.2PO4/rGO/C for lithium-ion batteries via in-situ coating of Mn0.8Fe0.2C2O4·2H2O precursor with graphene oxide

Nitrogen-doped Carbon Stabilized LiFe0.5Mn0.5PO4/rGO Cathode Materials for High-Power Li-ion Batteries

Three-Dimensional Carbon-Coated LiFePO4 Cathode with Improved Li-Ion Battery Performance

Electrospinning-assisted construction of 3D LiFePO 4 @rGO/carbon nanofibers as flexible cathode to boost the rate capabilities of lithium-ion batteries

Composites of Reduced Graphene Oxide and Fe 2 O 3 Nanoparticles Anchored on MoS 2 Nanosheets for Lithium Storage

Three-dimensional Carbon-Coated Si/rGO Nanostructures Anchored by Nickel Foam with Carbon Nanotubes for Li-ion Battery Applications

The Reduced Graphene Oxide Conductive Additives with a Certain Defect Concentration Enabling Rate-Capability of Lithium-Ion Batteries

Modifying the morphology and structure of graphene oxide provides high-performance LiFePO4/C/rGO composite cathode materials

Microsphere LiMn0.6Fe0.4PO4/C Cathode with Unique Rod-Like Secondary Architecture for High Energy Lithium Ion Batteries

LiFe0.95Mn0.05PO4@C film grown on multilayer graphene as a cathode material for lithium-ion batteries

In-situ synthesizing superior high-rate LiFePO 4 /C nanorods embedded in graphene matrix

Facile preparation of cellulose nanofiber derived carbon and reduced graphene oxide co-supported LiFePO4 nanocomposite as enhanced cathode material for lithium-ion battery

Mesoporous carbon-coated LiFePO4 nanocrystals co-modified with graphene and Mg2+ doping as superior cathode materials for lithium ion batteries

Catalytic Strategies Enabled Rapid Formation of Homogeneous and Mechanically Robust Inorganic‐Rich Cathode Electrolyte Interface for High‐Rate and High‐Stability Lithium‐Ion Batteries

Quenching-induced construction of graphene-wrapped Fe 3 O 4 composite as ultrahigh-performance Li-storage electrode

Pseudocapacitive Li-ion storage boosts high-capacity and long-life performance in multi-layer CoFe2O4/rGO/C composite

Integrated 3d Porous C-Mos2/Nitrogen-Doped Graphene Electrode for High Capacity and Prolonged Stability Lithium Storage