Abstract:This paper designs transmitted beamforming of multiple unmanned aerial vehicles so that they can simultaneously impose jamming signal to jamming targets and communication signal to communication users at the same frequency. Two cases in which the unmanned aerial vehicle swarm works in clock synchronization and clock asynchronization are considered. The proposed beamforming design algorithm coordinates the communication and jamming signal rationally and outperforms the conventional beamforming design algorithms. The integrated communication and jamming system is proposed by exploiting the diversity gain and flexible deployment of unmanned aerial vehicle (UAV)‐based distributed multiple input multiple output technology, which is expected to gain higher spectral efficiency and system scalability. This paper designs transmit beamforming of multiple UAVs so that they can simultaneously impose jamming signal to jamming targets and communication signal to communication users at the same frequency. The aim is to maximize the total jamming effect of all jamming targets while achieving a certain communication rate of communication users by optimizing the transmit beamforming matrices. Two cases are considered in which the UAV swarm works in clock synchronization and clock asynchronization. Specifically, the problem is formulated into a non‐convex optimization in the synchronous case. A near optimal solution is derived by decoupling the beamforming matrix into multi‐user interference suppression matrix and single‐user beamforming matrix. In the asynchronous case, the transmitter–receiver matching relation needs to consider and multiple optimization variables are highly coupled, penalty factors and intermediate variables to convert the optimization problem to convex programming are introduced. The simulation results show that the proposed beamforming design algorithm coordinates the communication and jamming signal rationally and outperforms the conventional beamforming design algorithms.

Learning-Based Predictive Beamforming for UAV Communications with Jittering

Location-aware Predictive Beamforming for UAV Communications: A Deep Learning Approach

Adaptive Hybrid Beamforming for UAV mmWave Communications against Asymmetric Jitter

Jittering Effects Analysis and Beam Training Design for UAV Millimeter Wave Communications

Learning-Enabled Radar-Assisted Predictive Beamforming for UAV-Aided Networks

Learning-Aided Blind Beam Adaptation for UAV Communication Systems With Jittering

Deployment and Robust Hybrid Beamforming for UAV MmWave Communications

Position Errors Analysis, Prediction and Recovery for UAV-enabled Virtual Antenna Array.

Robust Secure Energy Efficient Beamforming for mmWave UAV Communications With Jittering

Environment-aware UAV Communications: CKM Construction and Predictive Beamforming

Fusing Channel and Sensor Measurements for Enhancing Predictive Beamforming in UAV-Assisted Massive MIMO Communications

Near-Field Beamforming Algorithms for UAVs

Collaborative Beamforming for UAV Networks Exploiting Swarm Intelligence

Distributed Transmit Beamforming for UAV to Base Communications

Distributed beamforming design for UAV‐based integrated communication and jamming systems

UAV Jitter May Have Merit: A Fading Analysis in Air-to-Sea Two Ray Channels

Fully Decentralized Federated Learning Based Beamforming Design for UAV Communications

Low-Overhead Beam Alignment for High-Speed UAV Communications

Joint Trajectory and Passive Beamforming Optimization in IRS-UAV Enhanced Anti-Jamming Communication Networks

Active Reconfigurable Intelligent Surface Enhanced Secure and Energy-Efficient Communication of Jittering UAV

Distributed 3D-Beam Reforming for Hovering-Tolerant UAVs Communication over Coexistence: A Deep-Q Learning for Intelligent Space-Air-Ground Integrated Networks