Abstract:Steel corrosion is a critical factor in the seismic performance degradation of prefabricated concrete structures. In this study, the constant current accelerated corrosion method was employed to achieve targeted corrosion levels in steel bars within prefabricated column-footing joints connected by a grouted splice sleeve (GSS). Following that, a quasi-static cyclic experiment and numerical simulation method were employed to investigate the seismic performance of the specimens under various corrosion levels. Seismic performance indicators of specimens including the hysteresis curves, skeleton curves, bearing capacity, ductility coefficient, stiffness, and cumulative energy dissipation are examined. The results demonstrate that the failure modes of all column-footing joints are flexural failures. Specimens with steel bar corrosion levels below 14.1 % show negligible impact on the seismic performance. However, as the corrosion level increases, both the bearing capacity and cumulative energy dissipation capacity of the specimens significantly decrease. The horizontal displacement and ultimate displacement corresponding to the maximum bearing capacity are only 50.5 % and 45.2 %, respectively, compared to the noncorroded specimen. Additionally, a refined finite element model of prefabricated columnfooting joints with GSS connections under different corrosion levels is developed and the hysteresis and skeleton curves obtained by numerical simulation are verified to be in good agreement with the experimental results. The numerical simulation outcomes regarding peak load and corresponding horizontal displacement maintain a relative error within 15 % compared to the experimental results.

Experimental and Numerical Investigation on Seismic Behaviours of Beam-Column Joints of Precast Prestressed Concrete Frame under Given Corrosion Levels

Seismic Performance of Corroded Prefabricated Column-Footing Joint with Grouted Splice Sleeve Connection: Experiment and Simulation

Monotonic and fatigue behavior of steel-concrete composite beams subjected to corrosion

Corrosion-Induced Cracking Propagation Of Rc Beams Subjected To Different Corrosion Methods And Load Levels

Corrosion-induced Shear Performance Degradation of Reinforced Concrete Beams

EXPERIMENTAL INVESTIGATION AND DESIGN OF SEVERELY CORRODED REINFORCED CONCRETE BEAMS

Static and Fatigue Behavior of Steel-Concrete Composite Beams with Corroded Studs

Crack Propagation and Flexural Behaviour of Rc Beams under Simultaneous Sustained Loading and Steel Corrosion

Experimental investigation of composite steel-concrete beams with corroded studs

Performance of Reinforced Concrete Beams Corroded under Sustained Service Loads: A Comparative Study of Two Accelerated Corrosion Techniques

Study on Mechanical Properties of Steel-Concrete Composite Beam with Corroded Studs Under the Effect of Negative Bending Moment

Effect of Chloride-Induced Reinforcing Steel Corrosion on the Flexural Strength of Reinforced Concrete Beams

Shear Performance of Reinforced Concrete Beams with Corroded Stirrups in Chloride Environment

Residual strengths of reinforced concrete beams with heavy deterioration

Analytical Model for Concrete Jacketed RC Columns with Precorrosion and Postcorrosion Damages under Uniaxial Loading

Effect of Corrosion on Bond Behavior and Bending Strength of Reinforced Concrete Beams

NUMERICAL INVESTIGATION OF SEVERELY CORRODED REINFORCED CONCRETE BEAMS

Behavior of Steel–Concrete Composite Beams with Corroded Shear Studs under Negative Bending Moment

Seismic performance of exterior reinforced concrete beam-column joint with corroded reinforcement

Axial Loading Capacity Of Concrete-Jacketed Rc Columns With Pre- And Post-Corrosion Damage

Effects of Reinforcement Corrosion and Sustained Load on Mechanical Behavior of Reinforced Concrete Columns.