Abstract:The plate element with varying thicknesses follows distinct deformation laws. Consequently, the inverse finite element method (iFEM) must be adjusted to meet diverse plate elements. However, a challenge arises because it is difficult to distinguish between the thin and thick regions of most models. Therefore, a unified method is needed to handle the displacement field reconstruction of plate structures, which is an unsolved problem in this field so far. Additionally, the strain sensors are pasted at the center of mass symmetrically in traditional iFEM, limiting computational accuracy. Therefore, it is also necessary to propose a novel sensor optimization layout method to further optimize the robustness and accuracy in the proper region. To tackle these challenges, this article proposes an innovative method for full-field deformation measurement of thick and thin plates. This approach combines the principles of the iFEM, scaled boundary element theory, and the degenerate shell element. Initially, the mathematical model of discrete theoretical and experimental values of single-surface strains based on scaled boundary element theory is established for calculating the surface deformation field of plate structures. A bi-objective particle swarm optimization method is used to obtain the paste location and angle of the sensor distribution. Then, the degraded shell element model based on interpolated shape functions of 16-node spectral elements is proposed. This method solved the problem of pathological equations in the 3-D solid model for calculating thin plates and the problem of excessive stiffness coefficients at the edges for calculating thick plate. Next, the method establishes the relationship between the surface and mid-plane displacement field to realize the reconstruction of the entire domain displacement field. Finally, the simulation and experimental results show the high accuracy and universality of the method in reconstructing deformation field of plate structures with different width-to-thickness ratios under different load cases.

Strain‐based Displacement Field Reconstruction Method for Thin Rectangular Plate Through Orthogonal Deflection Curves Bridging

A Unified Full-Field Deformation Measurement Approach for Plates With Different Thickness

Research on Large Deflection Deformation Reconstruction of Elastic Thin Plate Based on Strain Monitoring

Displacement Field Reconstruction Technique for Plate-Like Structures Based on Model Superposition Method

An Effective Deformation Measurement Method for Distorted Elements in Mindlin Plates

Shape sensing of plate structures through coupling inverse finite element method and scaled boundary element analysis

Omnidirectional Full-Field Displacement Reconstruction Method for Complex Three-Dimensional Structures

A Unified Full-Field Deformation Measurement Method for Beam-Like Structure

Reconstruction of Full-Field Complex Deformed Shapes of Thin-Walled Special-Section Beam Structures Based on in Situ Strain Measurement

Deflection estimation of beam structures based on the measured strain mode shape

Strain/displacement Field Reconstruction and Load Identification of Bracket Arm Structure of High-Speed Maglev Train Based on Superposition Conversion Algorithm

Shape Sensing in Plate Structures through Inverse Finite Element Method Enhanced by Multi-Objective Genetic Optimization of Sensor Placement and Strain Pre-Extrapolation

An Analytical Method For The In-Plane Vibration Analysis Of Rectangular Plates With Elastically Restrained Edges

A Novel Strain Field Reconstruction Method for Test Monitoring

Displacement Response Reconstruction of Slender Flexible Structures Based on Cubic Spline Fitting Method

Novel Measurement Method for Full-field Bridge Strain and Displacement with Limited Long-gauge Strain Sensors

A Novel Displacement-Based Trefftz Plate Element with High Distortion Tolerance for Orthotropic Thick Plates

A displacement-based element model for solving the edge effect problem of Mindlin-Reissner plate

A Distributed Dynamic Load Identification Approach for Thin Plates Based on Inverse Finite Element Method and Radial Basis Function Fitting Via Strain Response

Study of deflection and strain distribution sensing of a simply supported rectangular plate based on fiber Bragg grating sensors

Global Displacement Reconstruction of Lattice Tower Using Limited Acceleration and Strain Sensors