Abstract:Femtosecond laser interference is a promising tool for micro-fabrication and micromachining of periodical structures on the surface of samples or inside transparent materials, but femtosecond laser pulses are very hard to interfere due to their spectrum widths may reach to several tens of nanometers, and their spectrum widths will be stretched by shorting the duration according to the Fourier transform. We realized two 25 fs pulses interference and encoded micro-gratings on Au-Cr thin films using this interference pattern. The interference patterns of two laser pulses with different pulse durations in sub-hundred femtosecond time domain were calculated to explore the influence of pulse durations on processing qualities of encoded micro-gratings. The results show that, the shorter pulses are preferable to fabricate micro-gratings with fine resolution on intractable materials, and longer pulses are helpful to improve encoding efficiency and contrast ratio of bright & dark interfered fringes. The differences between encoded micro-gratings on Au-Cr thin film using these interference patterns validated our analysis, which are hardly observed when pulse duration is longer than 100 fs mainly because the size of interfered area is larger than the focal spots. Moreover, the distance between two focal spots also has been chosen to identify our calculations, and the experimental results are agreement with the calculations.

High line density fused silica transmission gratings by deep reactive ion beam etching for ultra-short pulse laser compression

Fabrication of Optical Cavities with Femtosecond Laser Pulses

LASER DIRECT WRITING OF LONG PERIOD FIBER GRATING BY 800 NM FEMTOSECOND LASER PULSES

Fabrication of beam shapers in the bulk of fused silica by femtosecond laser pulses.

Fabrication of High Refractive Index-Modulation Structures in Fused Silica by Femtosecond Laser Pulses

Low-dispersion low-loss dielectric gratings for efficient ultrafast laser pulse compression at high average powers

Fabrication of micro-gratings on Au–Cr thin film by femtosecond laser interference with different pulse durations

Development of broadband high efficiency Mid-IR gratings for high-energy ultrafast lasers

Long-period fiber grating fabrication by high-intensity femtosecond pulses at 211 nm

Fabrication of echelette gratings by reactive ion beam etching of native substrate grating mask

High-Efficiency Multilayer-Coated Ion-Beam-Etched Blazed Grating in the Extreme-Ultraviolet Wavelength Region

Fabrication of Grating Structures on Silicon Carbide by Femtosecond Laser Irradiation and Wet Etching

Ion Beam Etching for Multilayer Dielectric Pulse Compressor Gratings with Top Layers of Hfo2

Optimal Design and Analysis of Wide-Band Near-Infrared Hybrid Dielectric Gratings with High Transmission Efficiency

Reactive Ion Beam Etching of Large-Aperture Multilayer Diffraction Gratings by Radio Frequency Ion Beam Source

Fabrication qualities of micro-gratings encoding dependence on laser parameters by two-beam femtosecond lasers interference

Transmission characteristics of long-period fiber gratings via radiation of femtosecond laser

Metal/multilayer-dielectric Coated Grating for Chirped Pulse Amplification Laser System

Silt-Beam Shaping Method for Femtosecond Laser Point-by-Point Inscription of Highly Localized Fiber Bragg Gratings with Enhanced Cladding Modes

Towards the Fabrication of High-Aspect-Ratio Silicon Gratings by Deep Reactive Ion Etching

Fabrication Of Extreme-Ultraviolet Blazed Gratings By Use Of Direct Argon-Oxygen Ion-Beam Etching Through A Rectangular Photoresist Mask