Abstract:Vortex pumps have good non-clogging performance and are widely used in the fluid transportation of food, sewage treatment, and mineral and coal slurry transportation. In order to design and manufacture a vortex pump with good performance and establish a method of optimum design, we must master the internal flow rules of the pump. Based on the self-design vortex pump (32WB8-12) experiment, the discharge-pump head (qv-H), discharge-pump shaft power (qv-P), discharge-pump efficiency (qv-η), and discharge-critical net positive suction head (qv-NPSHc) curves are obtained, and the qv-NPSHc curve shows an opposite tendency compared with the centrifugal pump. With the mathematical model selected with respect to the optimal condition, the three-dimensional internal flow within the vortex pump has been numerically simulated by a renormalization group k-ε (RNG k-ε) turbulence model. The static pressure (ps) and velocity distribution of the impeller and the middle section of the volute at 0°, 90°, 180°, and 270° are obtained, and the performance curves have been fitted using a CFX-calculated energy parameter. It was illustrated that the velocity field is relatively disordered and the flow in the impeller region is of a forced vortex character. The flow in the volute is similar to that of the combined vortex with backflow, which is a non-axisymmetric unsteady flow with quite high turbulence intensity. These factors are the main reasons for the relatively low efficiency of the vortex pump. The measurement of flow field in volute with a five-hole probe was conducted, and it is demonstrated that the numerical results are in good agreement with the flow field measurement data. An upward pressure gradient forms in the portal area of the impeller, and it is confirmed that the lowest pressure point is located in the upper position of the impeller hub. It is revealed that for the vortex pump to have advanced suction and anti-cavitation performance, the lowest pressure in the pump should be −4 × 104 Pa and it should be located at the center of the vortex chamber cavity.

In Exploration of Unsteady Dynamics of Powered-Vacuum Fluidic Conveyance

Vacuum-energized fluid conveyance simulation for pipe fluid

Explorative computation on vacuum-energized fluid conveyance

An Investigation in Performance of a Variable-Speed-Displacement Pump-Controlled Motor System

Dynamic Behaviors of Blade Cavitation in a Water Jet Pump with Inlet Guide Vanes: Effects of Inflow Non-Uniformity and Unsteadiness

Experimental and Numerical Investigation on the Cavity Regime and Drag Reduction of Ventilated Partial Cavity

Numerical visualization of flow field in complex passages of periodical fast switch valve

Study of the Cavitation Phenomenon Inside Roller Vane Pump

A Performance Test and Internal Flow Field Simulation of a Vortex Pump

Study on mechanism of unsteady gas-liquid two-phase flow in liquid-ring vacuum pump

Experimental Investigation on the Cavity Evolution and Dynamics with Special Emphasis on the Development Stage of Ventilated Partial Cavitating Flow

Dynamic Simulation in Guide Vane Opening Process of a Pump-Turbine in Pump Mode

Cavitation Mechanism and Effect on Pump Power-Trip Transient Process of a Pumped-Storage Unit

Experimental Development and Physical Analysis of Jet and Vortex Actuators

Experimental and Numerical Study of a Horizontal-Vertical Gas-Solid Two-Phase System with Self-Excited Oscillatory Flow

Coupling Vibration Investigation of Cyclone Separator Interacted With Unsteady Fluid

Test and analysis on the working process of dry scroll vacuum pump

Mechanism of the rotor-stator interaction in a centrifugal pump with guided vanes based on dynamic mode decomposition

Comprehensive analysis and identification of energy performance and unsteady two-phase flow patterns based on experiments and comparison between two distinct multiphase flow models

Research on Virtual Prototype and Digital Test Method of Pump-Fed Propulsion System

Critical penetrating vibration evolution behaviors of the gas-liquid coupled vortex flow