Abstract:This paper presents the design of a field-programmable gate array (FPGA)-based motion controller for robotic applications. In contrast to digital signal processor and microprocessor implementations, the control period of this system is fixed. Foregoing implementations on FPGA require microprocessor-based platforms for data interchange tasks consuming a large amount of resources; consequently, they could not be implemented on low logic density devices, or they use IP cores which limits the implementation of the system to only certain device families. This new motion controller architecture integrates control and communication modules in a single chip which permits an increase to the number of axis according to the system requirements. The proposed design presents a low consumption of logic resources; therefore, a considerable cost saving per axis is achieved. The system test has been carried out with a three-degree of freedom selective compliant assembly robot arm robot and a standard PC as master device. The digital filter parameters have been tuned by using a crossover frequency method. Step and profiled motion responses obtained show very good performance.

The Design and Realization of Motion Controller for Truss Robot

Multi-axis motion control system based on DSP and FPGA

Design of LED Production Equipment Molding Motion Controller Base on FPGA

Design and Realization of Motion Control Board Based on DSP and FPGA

Research of Robot Motion Controller Based on ARM + DSP + FPGA

Design and Realization of a Controller for Adaptive Truss Vibration Based on DSP

Multi-axis motion controller for robotic applications implemented on an FPGA

A High Performance FPGA-based Joint Controller with Hardware/software Co-Design Method

DSP + FPGA-Based Multi-Axis Controller for a 3-DOF Planar Parallel Robot

Study on Control System of Multi-axis Stepper Motor Based on DSP

Design of Multi-Axis Motion Controller and Its Application on Manipulators

Design of Tri-Axis Motion Controller Based on TMS320F2812

Design and Research on Four-axis Motion Controller Based on DSP and FPGA

Design of humanoid robot control system based on DSP and FPGA

Design of Laser Processing System of Five-Axis Motion Controller Based on DSP and FPGA

A REAL-TIME DATA-DRIVEN CONTROL SYSTEM FOR MULTI-MOTOR-DRIVEN MECHANISMS

Design of modular joint controller based on FPGA with software/hardware co-design methods

A Reconfigurable Platform for Motion Control Based on SOPC

A Motion Control Board Design Based on USB Interface

The Design of Motion Control Board Based on DSP

Implementation of Robot Motion Controller Based on ARM and FPGA