SIMULATION OF VIBRATIONS OF TING-KAU BRIDGE DUE TO VEHICULAR LOADING

F. T. K. Au,P. Lou,J. Li,R. J. Jiang,C. C. Y. Leung,P. K. K. Lee,K. Y. Wong,H. Y. Chan
2009-01-01
Abstract:The Ting Kau Bridge in Hong Kong is a cable-stayed bridge comprising two main spans and two side spans. The bridge deck is supported by three towers, an end pier and an abutment. Each of the three towers consists of a single reinforced concrete mast which reduces its section in steps, and it is strengthened by transverse cables and struts in the transverse vertical plane. The bridge deck is supported by four inclined planes of cables emanating from anchorages at the tower tops. In view of the heavy traffic on thin bridge, and threats from typhoons and earthquakes originated in areas nearby, the dynamic behaviour of long-span cable-supported bridges in the region is always an important consideration in their design. Baseline finite element models of various levels of sophistication have been built not only to match the bridge geometry and cable forces specified on the as-constructed drawings but also calibrated using the vibration measurement data captured by the Wind and Structural Health Monitoring System that began operation in 1998. This paper further describes the analysis of data of vehicular loading, as well as the simulation of vibrations of the bridge using the finite element models.
What problem does this paper attempt to address?