Abstract:Radar systems are a type of sensor that detects radio signals reflected from objects located a long distance from transmitters. For covering a longer range and a higher resolution in the operation of a radar, a high-frequency band and an array antenna are measures to take. Given a limited size to the antenna aperture in the front end of the radar, the choice of a millimeter-wave band leads to a denser layout for the array antenna and a higher antenna gain. Millimeter-wave signals tend to become attenuated faster by a larger loss of the covering material like the radome, implying this disadvantage offsets the advantage of high antenna directivity, compared to the C-band and X-band ones. As the radome is essential to the radar system to protect the array antenna from rain and dust, a metamaterial surface in the layer is suggested to meet multiple objectives. Firstly, the proposed electromagnetic structure is the protection layer for the source of radiation. Secondly, the metasurface does not disturb the millimeter-wave signal and makes its way through the cover layer to the air. This electromagnetically transparent surface transforms the phase distribution of the incident wave into the equal phase in the transmitted wave, resulting in an increased antenna gain. This is fabricated and assembled with the array antenna held in a 3D-printed jig with harnessing accessories. It is examined in view of S21 as the transfer coefficient between two ports of the VNA, having the antenna alone and with the metasurface. Additionally, the far-field test comes next to check the validity of the suggested structure and design. The bench test shows around a 7 dB increase in the transfer coefficient, and the anechoic chamber field test gives about a 5 dB improvement in antenna gain for a 24-band GHz array antenna.

Design of Patch Sensors for Microwave Nondestructive Evaluation of Aircraft Radomes

A Resonant Microwave Patch Sensor for Detection of Layer Thickness or Permittivity Variations in Multilayered Dielectric Structures

Design and Calculation of Electromagnetic Characteristics of Structure Absorbent Materials

Microwave Nondestructive Detection of Delamination in IC Packages Utilizing Open-Ended Coaxial Line Sensor

Design of an Invisible Radome by Frequency Selective Surfaces Loaded with Lumped Resistors

Microwave NDT Sensor for Coating Thickness Inspection on CFRP Using TM110 Odd Mode Cavity

Design and Characterization for Dual-Band and Multi-Band A-sandwich Composite Radome Walls

Detection of Debonding Defects Between Radar Absorbing Material and CFRP Substrate by Microwave Thermography

Detection of Delamination in IC Packages Using the Phase of Microwaves

A Method for Nondestructive Evaluation of Crack Depth on Metal Surface by Microwaves

A Novel Electrically Small Ground-Penetrating Radar Patch Antenna with a Parasitic Ring for Respiration Detection

An Electromagnetically Induced Transparency Inspired Antenna Sensor for Crack Monitoring

Design and structural analysis of a 70‐m metal space‐frame radome

Structural Health Monitoring of Aerospace Structures using Guided Electromagnetic Waves in a Dielectric Waveguide at Ka-Band

Microwave cavity resonator sensor with an octagonal cross section for thickness measurement of coatings on carbon fibre composites

Design and Characterization for A High-Temperature Dual-Band Radome Wall Structure for Airborne Applications

A Metamaterial Surface Avoiding Loss from the Radome for a Millimeter-Wave Signal-Sensing Array Antenna

Thermally Stable Wireless Patch Antenna Sensor for Strain and Crack Sensing

Small Distance Increment Method for Measuring Complex Permittivity With mmWave Radar

A new microwave cavity resonator sensor for measuring coating thickness on carbon fibre composites

A novel microwave-based non-destructive testing system for detection of sub-surface defects in natural flax fiber reinforced composite material