Abstract:As aerostatic bearings are used in high-speed metal-cutting machines to increase machining accuracy, there is the need to improve their characteristics, including compliance, which is usually high. In practical applications, a significant reduction of bearing compliance is often necessary, sometimes down to zero and even negative values, to ensure automatic compensation of the elastic deformation in the machine technological system. A decrease in compliance leads to deterioration in the dynamic performance of the bearing, so it is necessary to develop new designs that meet the above requirements. This article considers an aerostatic bearing, in which decrease in compliance is ensured by the use of air throttling with elastic orifices. To ensure its stability, the principle of combined external throttling was applied, which can substantially improve the dynamics of conventional aerostatic bearings. A mathematical model of the elastic orifice deformation was developed, together with the flow rate performance calculation method. The method ensured full qualitative and satisfactory quantitative agreement with the experimental data. The model was used in the mathematical modeling of the aerostatic bearing movement. The article also proposes a method to calculate the static load capacity and compliance of a bearing, as well as a numerical method for fast computation of its dynamic performance, which allows for real-time multi-parameter optimization by the bearing dynamic performance criteria. The study showed that there is an optimal set of design parameters for which low, zero, and negative static compliance of the bearing is ensured, with the necessary stability margin, high speed, and the non-oscillatory nature of the transient processes.

Pneumatic Stability Analysis of Single-Pad Aerostatic Thrust Bearing with Pocketed Orifice

Pneumatic hammer characteristics of the aerostatic thrust bearing with central orifice and pressure-equalizing groove

Improving the Pneumatic Hammer Stability of Aerostatic Thrust Bearing with Recess Using Damping Orifices

The Simulation Study of a New-Type Frictionless Pneumatic Cylinder

Analysis of pneumatic hammer in rectangular aerostatic thrust bearing with groove

Study on the pneumatic hammer phenomenon of aerostatic bearings based on the empirical mode method: numerical and experimental analysis

Dynamic Performance of Partially Orifice Porous Aerostatic Thrust Bearing

Analysis of Dynamic Stiffness and Damping of Partial Porous Aerostatic Thrust Bearings

Experimental Study on Multi-Decked Protuberant Foil Thrust Bearing with Different Number of Thrust Pads

A Theoretical and Experimental Study on the Stiffness of Aerostatic Thrust Bearings with Vacuum Preloading

Lubrication mechanism and characteristics of aerostatic bearing with close-spaced micro holes

Experimental Force Coefficients of a Hydrostatic Thrust Bearing and Comparisons to Predictions

Numerical and Experimental Studies on Stability of Cryogenic Turbo-Expander with Protuberant Foil Gas Bearings

Effect of Surface Waviness on the Performances of an Aerostatic Thrust Bearing with Orifice-Type Restrictor

Stability analysis of rubber-supported thrust bearing in a rotor-bearing system used in marine thrusters under disturbing moments

Novel Aerostatic Bearings with Hermetically Squeeze Film Dampers for the Improvement of Stability: Theoretical and Experimental Investigations

A Stability Analysis for a Journal-thrust Hybrid Floating Ring Bearing with the Cavitations Influence

Study on Static Characteristics of Annular Array Microporous Aerostatic Bearing

Suppression Effect of Slope under the Orifice on Drastic Pressure Depression Phenomenon of Aerostatic Bearing

Research on Load Characteristics of Aerostatic Journal Bearing with Pocketed Orifice-Type Restrictor

Mathematical Modeling on Statics and Dynamics of Aerostatic Thrust Bearing with External Combined Throttling and Elastic Orifice Fluid Flow Regulation