Abstract:NEED-The effect of dimensional variability of sheet thickness (tolerance) and tool misalignment is poorly understood for the clinching process. Finite element analysis (FEA) is valuable but requires a lot of and is difficult to verify in this situation due to the asymmetrical geometry and nonlinear plasticity. OBJECTIVE-The objective of this work was to determine the effect of thickness tolerance, tool misalignment and sheet placement (top vs. bottom) in the clinching process, by use of analogue modelling with plasticine. METHOD-Experiments used a scaled-up punch and die, with plasticine as the analogue. Thickness tolerances were represented by sheet thicknesses of 11 and 7 mm, 12 and 8 mm, 8 and 12 mm and 13 and 9 mm for upper and lower sheets, respectively. Two types of lubricant were tested between sheets: glycerine and silicone oil. Angular variability was also introduced. Measured parameters were interlock (also called undercut) and neck thickness. Analogue results for deformation were compared with microscopy of metal clinching. FINDINGS-The results reveal that the multiscale analogue model is an efficient tool for studying the effect of dimensional deviation on a clinch joint. Thickness tolerance showed a critical relationship with interlock, namely a reduction to about half that of the nominal, for both maximum and least material conditions. Increased angular misalignment also reduced the interlock. Compared with glycerine, silicone oil tests showed reduced interlock, possibly the result of a lower coefficient of friction. ORIGINALITY-This work demonstrates the usefulness of analogue modelling for exploring process variability in clinching. The results also show that significant effects for sheet placement are ductility, lubricant (friction), thickness of samples and tool misalignment.

Optimization of Geometrical Design of Clinching Tools in Clinching Process with Extensible Dies

Optimization of Geometrical Design of Clinching Tools in Flat-Clinching

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Steel-aluminum Plastic Clinching of an Inclined Wall Die

APareto Optimal Strategy Based on Multi-objective Optimization for the Clinching Tools

Pareto optimal solution set strategy based on multiobjective optimization for the clinching tools

Numerical and Experimental Investigations of the Two-Step Clinching Process with a Bumped Die

Investigation on Mechanical Behavior of Clinched Joint Using Extensible and Flat Die Techniques

Numerical investigation of tool parameter influence on the interlock forming during flat clinching process

Investigation Of Flat Clinching Process Combined With Material Forming Technology For Aluminum Alloy

Numerical Simulation and Optimization of Press Forging Process for Aviation Connector

Steel‐aluminum clinched joints mechanical properties and strength prediction under different geometric parameters

Influence of process variations on clinch joint characteristics considering the effect of the nominal tool design

Experimental investigation of the novel dieless clinching process free of blank holder

Optimized Design for a Combined Die with Two Stress Rings in Cold Forging Considering Thermal-Mechanical Effects

Study on the Forming Process Parameters of Sleeper Fixed Reinforcing Plate Using Orthogonal Experiment Method by Numerical Simulation Technology

Study on the Forming Process Parameters of Automobile Front Panel Reinforcing Plate Using Orthogonal Experiment Method by Numerical Simulation Technology

Optimizing Die Structure Using Finite Element Simulation

Structural design of stamping die of advanced high-strength steel part for automobile based on topology optimization with variable density method

Experimental Research on the Compressed Joints with Different Geometrical Parameters

Multiscale Analogue Modelling of Clinching Process to Investigate Thickness Tolerance and Tool Misalignment