Abstract:The undesired synchronous vibration due to rotor mass imbalance is a main disturbance source in all rotating machinery including active magnetic bearing (AMB)-rotor systems. In the AMB-rotor system, imbalance compensation, which causes the AMB actuators to spin a rotor about its geometric axis, and automation balancing, which spins a rotor about its inertial axis, are two kinds of common control aim for the rotor imbalance control. In this study, the internal relation between the imbalance compensation and the automation balancing is analyzed and a uniform control method is proposed. With the identical control algorithm, the proposed control method can realize the automation balancing or the imbalance compensation, respectively, by switching the controller's junction position in the original control loop. The proposed control method does not depend on the dynamic plant model, because its algorithm is based on the real-time identification for the Fourier coefficient of the rotor imbalance disturbance. In this paper, the process of identification algorithm is given in detail and all the possible junction forms of the controller are illustrated. By the simulations, the identification performances of the control algorithm are compared in the conditions with three variable factors, including the signal noise ratio (SNR), the imbalance phase and the identification delay time. The noise level has considerable influence on the identification precision, but the imbalance phase has little. To prolong the identification delay time will be of benefit to improve the identification precision but slow down the identification process. Experiments, which are carried out on an AMB-rigid rotor test rig, indicate that by switching the junction position of the controller in control loop, both kinds of rotor imbalance control can achieve the good effectiveness. [DOI: 10.1115/1.4005279]

Multi-harmonic motions of bearing cage affected by rotor unbalance

Rigid Rotor Dynamic Balancing with the Influence Coefficient Method

Unbalance Compensation by Recursive Seeking Unbalance Mass Position in Active Magnetic Bearing-Rotor System

Vibration Characteristics of Aeroengine's Rotor System During Maneuvering Flight

On-line Unbalance Identification of Flexible Rotor System

Unbalance Compensation for Active Magnetic Bearing Rotor System Using a Variable Step Size Real-Time Iterative Seeking Algorithm.

Benchmark solutions for the dynamic analysis of general rotor-bearing system with arbitrary linear boundary conditions

Vibration characteristics of rotor-bearing system with angular misalignment and cage fracture: Simulation and experiment

Dynamic characteristics of ball bearing-coupling-rotor system with angular misalignment fault

Study on the Dynamic Response of an Unbalanced Rotor System Supported by Ball Bearings

Synchronous Vibration Control for Magnetically Suspended Rotor System Using a Variable Angle Compensation Algorithm.

Vibration Responses of the Bearing-Rotor-Gear System with the Misaligned Rotor

Output Feedback Dynamical Compensation Via EigenStructure Assignment for Active Magnetic Bearings-Rigid Rotor Systems.

A uniform control method for imbalance compensation and automation balancing in active magnetic bearing-rotor systems

Response Analysis Of A Linear Rotor-Bearing System Under Combined Non-Stationary Seismic And Harmonic Excitations

Field dynamic balancing for active magnetic bearings supporting rigid rotor shaft based on extended state observer

Nonlinear Dynamic Behaviors of an Imbalance Rotor on Multi-Lobe Bearings

External and internal coupling effects of rotor's bending and torsional vibrations under unbalances

Model verification and vibration analysis of the four-disk hollow flexible shaft rotor system

Nonlinear dynamics of full-ceramic bearing-rotor system considering structural defects in cage pockets

A Comprehensive Dynamic Model to Investigate the Stability Problems of the Rotor–bearing System Due to Multiple Excitations