Abstract:The rotary compressors are currently witnessing a trend towards high-speed operation, resulting in an increased frequency of valve motion and a higher mass flow rate through the discharge valve. Consequently, high-speed operation leads to intensified impact between the valve and both the valve stopper and valve seat, thereby posing challenges to the reliability of the valve. Simultaneously, the dynamic characteristics of the valve at high operating speeds exert a significant influence on the compressor's performance. This paper develops a threedimensional fluid-structure interaction (FSI) model to investigate the dynamic characteristics and reliability of the valve in a high-speed rotary compressor while considering heat transfer during the flow process within the cylinder. The proposed model shows better agreement with the experiment. The study revealed that as the rotational speed increases, there is an obvious rise in over-compression loss and a pronounced valve closure delay, which increases the impact velocity of the valve. The valve experiences two peaks of equivalent stress within one cycle, rendering it susceptible to fail at high speeds. The adoption of a double-valve structure at a rotational speed of 12,000 rpm leads to a significant reduction in over-compression loss by 62.9 %, an increase in volumetric efficiency by 6.7 %, a maximum decrease in impact velocity by 54.5 %, and a maximum decrease in equivalent stress by 25.6 %. The reliability of the double-valve structure under 12,000 rpm was proved by an endurance experiment. Besides, the asymmetry in the opening process of the two valves has been unveiled for the first time.

Fluid–solid Coupling Numerical Simulation for the Performance Prediction and Valve Dynamic Analysis of a Rotary Compressor

Fluid-structure interaction analysis and optimization study of suction valves in small refrigeration compressors

Simulation and Experiment Study on Dynamic Characteristic of Reed Valve of Reciprocating Compressor Based on Fluid-Structure Interaction Model

Modeling the valve dynamics in a reciprocating compressor based on two-dimensional computational fluid dynamic numerical simulation

Numerical Simulation of the Valve Motion in Automotive Air Conditioning Compressors

Numerical Simulation for Flow of Rolling Piston Type of Rotary Compressor

Investigation of Flow Behaviour and Heat Rejection for an Air-Cooled Small Multi-Stage Swash-Plate Compressor

Simulation of Dynamic Characteristics of Moving Magnet Linear Compressor for Refrigerator

Investigation of Discharge Valve in Ultra-High-speed Rotary Compressors: an Experimental and FSI Simulation-Based Study

CFD Simulation of a Rotary Compressor with Gas Injection

Calculation Of Flow Coefficient And Effective Action Area Coefficient Of Compressor'S Reed Valve Based On Fluid-Solid Coupling

Numerical study on transient effective flow and force areas of reed valve in a rotary compressor

Modeling and Performance Analysis of Rotary Compressor Considering Multi-Body Coupling and Bearing Deformation

Numerical Simulation of Thermal and Fluid-Dynamic Behaviour of Reciprocating Compressor

Dynamic Model and Numerical Simulation for Synchronal Rotary Compressor

Equation-based Performance Simulation for Centrifugal Compressor

Analysis, modeling and simulations of an innovative sliding vane rotary compressor with a rotating cylinder

Coupled Fluid-Thermal-Solid Simulation of Axial Through-Flow Rotating Cavities

Numerical Simulation on Fluid Dynamic Behavior of High-pressure Safety Valves

Dynamic modeling and characteristics analysis of sliding vane in a high-speed rotary compressor considering groove distribution and multi-body coupling

The Numerical Simulation on Fluid Property of Inlet Volute in an Axial Flow Compressor Based on CFD