Abstract:The current-voltage characteristics of superconductors are commonly determined by means of a standard 4-probe DC measurement technique. In coated conductors, however, one often encounters problems due to weak or no stabilization and in such case, when the risk of burning the tape is high, the 4-probe approach can fail. In other cases such as in HTS cable structures, besides vulnerability and high risk of damage, it may also be difficult to achieve a high critical current level with a power supply that is normally used to characterize single strands. We therefore investigated an alternative method to determine the DC I-V curve, based on measuring the AC transport loss as a function of frequency in overcritical current range. In the AC regime, both the hysteretic loss component and the joule dissipation are present for applied transport currents exceeding the critical current Ic. In this work, AC loss measurements at different frequencies are related to different electric fields in DC and a curve similar to the DC I-V is obtained. From this curve, the power index N and Ic values are estimated. AC regime operation can be more beneficial for two reasons: firstly, because very high currents can be achieved easily by using a transformer; secondly, because the effective joule heat dissipation with overcritical AC currents is much lower than that with DC of the same amplitudes. In the experiment, we used a 4 mm wide YBCO reference tape with 20 {\mu}m of Cu-stabilization. For the comparison with AC transport loss, the sample was measured with the standard 4-probe technique and remained stable even in overload condition. To support our study, numerical simulations, reproducing both transient and stationary operation conditions, were performed. A similar relation between the AC current transport loss and the I-V curves was also observed in the simulations.

AC Loss Measurement of HTS Coil under Periodic Current

Experimental Study on AC Loss of 1G and 2G HTS Coils with an Identical Structure, Geometry and Number of Turns

A Loss Measurement Approach of Power Magnetic Components under Practical Power Electronics Conditions

AC loss calculation in REBCO coils or stacks by solving the equation of motion for current using an integration approach

AC Analysis of a High Temperature Superconductor Coil with Short Circuits

Losses in Superconductors under Non-Sinusoidal Currents and Magnetic Fields

Experimental AC loss study on REBCO coil assemblies coupled with an iron cylinder

Computation of Losses in HTS Under the Action of Varying Magnetic Fields and Currents

Simulation of AC Loss in Small HTS Coils with Iron Core

Theoretical and experimental study of AC loss in HTS single pancake coils

Comparison of AC Losses of YBCO Circular Pancake Coils and Infinitely Long Stack Approximation

Simulation of Current Profile and AC Loss of HTS Winding Wound by Parallel-Connected Tapes

Determination of I-V Curves of HTS Tapes From The Frequency Dependent AC Transport Loss

Optimization of HTS Transformer Parameters and Analysis of AC Losses Under Harmonic Conditions

3-D Modeling of AC Loss in D-Shaped HTS Coils Using and - Formulation-Based Finite Element Methods

A Novel Estimation Model for Hysteresis Loss Based on Semi-Minor Loops

Effect of local and global screening current on the current decay in closed-loop HTS coils

Investigation of AC Loss in HTS Cross-Conductor Cables for Electrical Power Transmission

An Investigation on AC Loss Reduction for Permanent-Magnet Superconducting Electrical Machine

AC loss modelling in superconducting coils and motors with parallel tapes as conductor

Fast evaluation of the critical current of high-temperature superconducting coils based on the integral method