Effect of Pulsed Current Treatment on Microstructure and Properties of 304 Stainless Steel Ultra-Thin Strip after Rolling
Qi Liu,Wanwan Fan,Zhongkai Ren,Tao Wang,Qingxue Huang
DOI: https://doi.org/10.1186/s10033-024-01119-0
IF: 2.964
2024-12-05
Chinese Journal of Mechanical Engineering
Abstract:The annealing process is usually used to heat-treat cold-deformed 304 stainless steel to improve its microstructure and properties to a certain extent; however, it requires a high temperature and a long time. Because the thickness of the ultrathin strip reaches the micrometer level, it has only one or several layers of grains in the thickness direction, and the control of morphology and performance is complex. In this study, pulsed current loading was used to replace traditional annealing for treating ultrathin strips of cold-rolled 304 stainless steel. After loading a 25 W pulsed current treatment for 5 min on the cold-rolled sample, which had a thickness of 0.035 mm and width of 6 mm, complete recrystallization occurred, and the mechanical properties were significantly improved. At this point, the measured temperature was 540 °C. When annealing was used to treat the sample with the same temperature and for the same duration, the microstructure was still dominated by deformed crystals, and the mechanical properties were poor. When annealing was used to obtain a microstructure and properties similar to those obtained via 25 W electrical treatment, the required annealing temperature and time were 810 °C and 60 min, respectively. Pulsed current can increase the vacancy diffusion flux in the sample, accelerate the atomic movement, reduce the recrystallization activation energy, and make the cold-rolled 304 stainless steel ultrathin strip completely recrystallize at a lower temperature and in a shorter time. As the current power continued to increase, the recrystallized grains grew. When the pulsed current power was increased to 25 W, the recrystallized grains grew negligibly. Both recrystallization and grain growth have power thresholds. This study provides a novel approach for regulating the microstructure and mechanical properties of ultrathin cold-rolled 304 stainless steel strips.
engineering, mechanical