Abstract:High-pressure torsion (HPT)processing with floating cavity was carried out under the applied pressure of 1.5 GPa with the revolution from 5 to 20 turns at the temperature of 300 °C, and the WCu gradient material with noble bonding interface and significant grain refinement was successfully obtained. The microstructure evolution and atomic diffusion around the bonding interface were analyzed by electron backscatter diffraction (EBSD), transmission electron microscopy (TEM) and energy dispersive X-ray spectroscopy (EDS) in a field emission scanning electron microscope (SEM). The mechanism of large shear strain on the microstructure evolution and diffusion ability of tungsten and copper at the interface was investigated. The results show that HPT processing with floating cavity can effectively refine microstructure of tungsten and copper to submicron. After 5 turns of HPT deformation, the grain size of copper was significantly refined to 0.59 μm but experiences slight increases to 0.8 μm with the additional revolution number to 20 turns, and the ultrafine equiaxed grains with relatively straight grain boundaries and few dislocations within grains were formed under the continuous dynamic recrystallization mechanism. However, the microstructure of tungsten was continuously refined within 20 turns of HPT processing due to the accumulation shear deformation, and a lamellar microstructure was formed along the WCu bonding interface with a gradient distribution in the width of banded grains from 0.06 μm at the interface to 0.33 μm towards the tungsten matrix. In addition, with the increase of torsion strain, the diffusion lengths of tungsten and copper gradually increasing to 1.6 μm and 6.2 μm, the interdiffusion coefficient of tungsten in copper remained basically constant, while the value of copper in tungsten increases continuously. The high density of defects and ultrafine grains with high angle boundaries introduced by large shear deformation of 20 turns of HPT processing play roles in the rapid diffusion paths to accelerate the atom diffusion and the interdiffusion coefficient of tungsten and copper is enhanced by 0.48– 1.79× 108 times compared to the lattice diffusion.

Effect of High-Pressure Torsion on Recrystallization Behavior of Pure Tungsten

Texture evolution and deformation - induced amorphization in high pressure torsion of W

Thermal stability of the HPT-processed tungsten at 1250 – 1350 °C

The Influence of Crystal Defects on the Elastic Properties of Tungsten Metals

High-pressure Preparation of Bulk Tungsten Material with Near-Full Densification and High Fracture Toughness

Effect of High-Pressure Torsion Temperatures on the Precipitation and Properties of Cu-Cr Alloy

The Evolutions of Microstructure, Texture and Hardness of A1050 Deformed by HPT at the Transition Area

Grain refinement and enhanced diffusion of W Cu gradient material processed by high pressure torsion with floating cavity

The effects of electropulsing on the recrystallization behavior of rolled pure tungsten

Microstructural Evolution of Metastable Austenitic Steel During High-Pressure Torsion and Subsequent Heat Treatment

Effect of High-Pressure Torsion on Phase Formation and Mechanical Properties of a High-Entropy TiZrHfMoCrCo Alloy

Inhomogeneous Deformation Substructure and Its Effect on the Recrystallization Behavior of Yttria Dispersion-Strengthened Tungsten Plate

Structure and magnetic properties of nanocrystalline SmCo5 and SmCo3Cu2 prepared by using high-pressure torsion method

Effect of V content on the microstructure and mechanical properties of HPT nanostructured CoCrFeMnNiVx high entropy alloys

Microstructural evolution and mechanical properties of biomedical Co-Cr-Mo alloy subjected to high-pressure torsion

Microstructure Evolution during High-Pressure Torsion in a 7xxx AlZnMgZr Alloy

Influence of HPT and Accumulative High-Pressure Torsion on the Structure and Hv of a Zirconium Alloy

Quasicrystal phase evolution and mechanical properties of Mg-3.5Zn-0.6Gd alloy processed by high-pressure torsion

Strength enhancement of an aluminum alloy through high pressure torsion

EFFECT OF HIGH PRESSURE TORSION ON STRUCTURE AND MECHANICAL PROPERTIES OF Al–Ca–Cu ALLOY

Strain-Hardening Stages and Structure Evolution in Pure Niobium and Vanadium upon High Pressure Torsion