Cathodic Disbondment Resistance with Reactive Ethylene Terpolymer Blends

Corey T. Love,Guijun Xian,Vistasp M. Karbhari

DOI: https://doi.org/10.1016/j.porgcoat.2007.07.022

IF: 6.6

2007-01-01

Progress in Organic Coatings

Abstract:Adhesion to metallic substrates can be improved through the addition of polar functional groups, which bond with surface groups on the metal substrate. Additionally, polar interactions have been shown to increase adhesive strength even in wet environments (such as in the case for cathodic protection). A polymer blend is proposed as a coating material to provide adequate protection against the diffusion of moisture and air to the metallic surface along with superior adhesion even in the presence of wet and corrosive environments to resist cathodic disbondment. A reactive ethylene terpolymer (RET) of ethylene/n-butyl acrylate/glycidyl methacrylate (E/nBA/GMA) was compounded with HDPE to develop a potential coating material. The HDPE component offers high chemical and moisture resistance to permeation, while the RET component provides the material with high polarity and reactivity, which enhances adhesion to the substrates to be coated. The introduction of the reactive ethylene terpolymer decreases the magnitude of cathodic disbondment area of polyethylene coatings. After applying a cathodic potential to the coating substrate, the adhesive strength was observed to remain the same for silane-pretreated steel dollies. Without silane pretreatment, post-CD adhesive loss resembles that of the open circuit “wet” condition. EDAX data in conjunction with oxygen and water vapor transmission rates suggest an initial stage of disbondment where interfacial oxide is dissolved resulting in the delamination of coating around the initial defect. This initial disbondment zone acts like a moving crack tip creating larger areas of disbondment where interfacial bonds are degraded by the ingress of moisture and ions along the interface.