Abstract:Mordenite composite membranes were prepared by means of coating a porous α-alumina support with nanosized mordenite seeds followed by hydrothermal crystallization. A systematic investigation was performed on the influence of several factors such as ageing of the reaction mixture, alkalinity, salt addition and temperature on the formation of a mordenite membrane on the seeded support. The ageing of the reaction mixture reduces the growth rate of mordenite crystal along a-axis and b-axis but hardly influences the growth rate along c-axis. As a result, the boundaries between the surface crystals become a little larger with prolonging the period of ageing time. The growth rate of the mordenite crystal along individual axes increases first and then decreases with increasing concentration of sodium hydroxide. A higher alkalinity is unfavorable for the formation of a continuous mordenite membrane. The addition of salt in the reaction mixture has different effect on the growth rate of the mordenite crystal along each axis. With increasing the amount of salt, there was hardly influence on the growth rate along c-axis, whereas an obvious decline was observed in the growth rate along either a-axis or b-axis, which enlarges the boundaries between the surface crystals. The growth rate of the mordenite crystal increases more along c-axis than that along a-axis or b-axis with increasing temperature for hydrothermal crystallization. The use of a temperature as high as 473 K produces a membrane composed of bar-like crystals with larger boundaries.

Microwave Synthesis of High-Quality Mordenite Membrane by a Two-Stage Varying Heating-Rate Procedure

Preparation of Mordenite Composite Membranes with Seeding

Rapid Synthesis of Mordenite Crystals by Microwave Heating

Preparation of Highly Water-Selective Mordenite Membranes Via Post-Synthetic Treatment with Oxalic Acid

Highly water-selective mordenite membranes prepared via hydrothermal post-treatment in a dilute hydrochloric acid solution

Effect of Post-Treatment in the Hydrochloric Acid Solution on the Pervaporation Performance of Mordenite Membranes

Preparation of high-performance zeolite membrane on a macroporous support by novel intermittent hydrothermal synthesis

Preparation of high-performance zeolite NaA membranes in clear solution by adding SiO2 into Al2O3 hollow-fiber precursor

Preparation and Characterization of Small Crystal Mordenite Membrane

Growth Mechanism of a Preferentially Oriented Mordenite Membrane

Ultrasonic-assisted Fabrication of High Flux T-type Zeolite Membranes on Alumina Hollow Fibers

Synthesis and Low-Temperature Detemplation of High-Silica Mfi Zeolite Membranes

Manipulation of the Surface Microstructure and Its Effects on the Flux of NaA Zeolite Membranes in Pervaporation

Preparation of zeolite MFI membranes on defective macroporous alumina supports by a novel wetting–rubbing seeding method: Role of wetting agent

Microstructure Manipulation of MFI-type Zeolite Membranes on Hollow Fibers for Ethanol–water Separation

Preparation of zeolite MFI membranes on alumina hollow fibers with high flux for pervaporation

Preparation of zeolite A membranes by microwave heating

The preparation of zeolite NaA membranes on the inner surface of hollow fiber supports

Synthesis of Hierarchical LTA Zeolite Membranes by Vapor Phase Transformation

Preparation of Zeolite NaA Membranes on Macroporous Alumina Supports by Secondary Growth of Gel Layers

Effects of the synthesis hydrogel on the formation of zeolite LTA membranes