Abstract:The manufacturing process is inevitably accompanied with the production of scraps, which leads to resource waste and environmental pollution. Recycling and remanufacturing are the most commonly used approaches for metal scraps due to their well-established advantages from economic and environmental perspectives. In this study, spinning experiments with 2195 Al-Li alloy tailor welded blanks produced by friction stir welding from metal scraps were conducted under different process parameter designs. And then the effects of various process parameters on spinning of thin-walled curved surface parts were systematically studied. The results of the corresponding experimental groups show that the roller attack angle, the spinning clearance, and the installation method of tailor welded blanks have the most significant effect on the weld torsion angle. In addition, it was found that along the longitude direction of spun parts, the surface roughnesses of the weld of spun parts were greatly improved under the roller nose radius of 10 mm, the spinning clearance of 1.0 mm, the constant linear velocity, and the installation method of tailor welded blanks (the lower surface of tailor welded blanks is spun by rollers), while the process parameters have little significant effect on the surface roughness along the latitude direction of spun parts. Furthermore, it can be concluded that the forming profiles of spun parts fitted the mandrel well under the roller nose radius of 6 mm, double rollers, the roller attack angle of 30° and 45°, spinning clearance of 1.5 mm, and the installation method of tailor welded blanks (the upper surface of tailor welded blanks is spun by rollers). The research results will provide guidance for the precise spinning of thin-walled curved surface parts with tailor welded blanks. Thereby, it is also beneficial for green manufacturing involving recycling and remanufacturing of metal scraps.

Study on Spinning Process of Thin-Walled Curvilinear Generatrix Parts Based on Variable Thickness Blanks

Research on Design Method of Variable Thickness Blanks for Aluminum Alloy Head Spinning Forming

Study of Dieless Radial Spinning for Thick-Walled Cylindrical Parts With External Grooves

Study on Spinning Process of A Thin-Walled Aluminum Alloy Vessel Head with Small Ratio of Thickness to Diameter

Effects of Forming Parameters on Deformation Uniformity of Thin-walled Parts during Multi-pass Spinning

Numerical Simulation Research on A New Spinning Process: Double-Roller Clamping Spinning Process

Process factors influencing spinning deformation of thin-walled tubular part with longitudinal inner ribs

Study on the spinning process of thin-walled aluminum alloy vessel head

Study on Flange-Constrained Spinning Process for Hemispherical Aluminum Alloy Part

Spinning of curvilinear generatrix parts without mandrel based on main and auxiliary rollers

Study on Counter-Roller Spinning Technology of Large Diameter Aluminum Alloy Cylindrical Parts

Numerical Investigation of Effects of Deformation Allocation on Multi-Pass Conventional Spinning Process of Curvilinear Generatrix Parts

A Systematic Study on the Effects of Process Parameters on Spinning of Thin-Walled Curved Surface Parts With 2195 Al-Li Alloy Tailor Welded Blanks Produced by FSW

Multi-pass Spinning of Thin-Walled Tubular Part with Longitudinal Inner Ribs

Research on a New Counter-Roller Active Spinning Process for Forming Al Alloy Thin-Walled Cylinders

Experiment of Laser Assisted Shear Spinning for Aluminum Alloy Spherical Thin-Walled Parts

Numerical simulation and experimental study on non-axisymmetric spinning with a groove at the middle of the tube

Finite Element Analysis of Stress and Strain Field in Thin-wall Taper Workpiece During Spinning Forming

Study of Deformation Mechanism of Backward Ball Spinning of Thin-Walled Tube with Longitudinal Inner Ribs

Research on the Multi-Pass Shear Spinning Technology of Small-Angle Conical Workpieces

Analysis of ball spinning formability of thin-walled tubular parts of aluminum alloy